Panasonic KV-S3065CL / KV-S3065CW (serv.man4) Service Manual ▷ View online
(Fig.7.2.2-2) Cleaning Position
Caution:
The Image Sensor Covers (F) and (B) or their surroundings may be hot after scanning a lot of documents continuously.
Be sure to allow the inside of the scanner to cool down before performing any maintenance or coming in contact with
the inside of the unit.
the inside of the unit.
25
KV-S3065CLSERIES / KV-S3065CWSERIES
7.2.3. Cleaning-2 (Others)
How to clean sensors (detectors) and reflectors.
Remove the brush from the accessory Blower and blow off the dirt with the blower.
(1) Remove the Exit Roller. (See 8.3.17.)
(2) Wipe off the dirt on the Exit Roller’s surfaces all the way
around them with the accessory Roller Cleaning Paper or
Model KV-SS03.
Model KV-SS03.
(3) Remove the ENDING (FRONT) SENSOR Board.
(See 8.4.4.)
(4) Blow off the dirt on the surface of the Ending (Front) Sensor
with an accessory blower.
(5) Remove the Straight Exit Roller. (See 8.3.14.)
(6) Wipe off the dirt on the Straight Exit Roller’s surfaces all the
way around them with the accessory Roller Cleaning Paper
or Model KV-SS03.
or Model KV-SS03.
(7) Remove the ENDING (REAR) SENSOR Board.
(See 8.4.17.)
(8) Blow off the dirt on the surface of the Ending (Rear) Sensor
with an accessory blower.
26
KV-S3065CLSERIES / KV-S3065CWSERIES
7.3. Replacing Limited Life Parts
7.3.1. Replacing Paper Feed Module
(1) Turn off the scanner. (See 7.2.1-(1).)
(2) Pull the Front Door Release to open the Front Door. (See
7.2.1-(2).)
(3) Pull down the Paper Feed Module in the direction of the
arrow (1), hanging your finger on the center shaft of the
module.
module.
(4) Push down the Green Lock- levers on both sides in the
direction of the arrow (2) to release and remove the Paper
Feed Module from the scanner.
Feed Module from the scanner.
27
KV-S3065CLSERIES / KV-S3065CWSERIES
(5) Open the optional Roller Exchange Kit (KV-SS017 or KV-
SS018), and take out a new Paper Feed Roller Module.
(6) Install the new Paper Feed Roller Module into the guide
grooves of both sides in the direction of the arrows (1).
Note:
Be sure to match both bearings of the module with
the guide grooves on both sides of the chassis.
the guide grooves on both sides of the chassis.
(7) Push up the Green Lock-levers and Paper Feed Module in
the direction of the arrows (2), (3) to lock it to the scanner.
(8) Close the Front Door slowly until it clicks into place.
Note:
After replacing the above Paper Feed Roller Module
and the following section’s (7.3.2) Retard Roller,
execute “Clear Counter” for replacing roller, with
Service Utility. (See 9.3.4.)
and the following section’s (7.3.2) Retard Roller,
execute “Clear Counter” for replacing roller, with
Service Utility. (See 9.3.4.)
28
KV-S3065CLSERIES / KV-S3065CWSERIES
Click on the first or last page to see other KV-S3065CL / KV-S3065CW (serv.man4) service manuals if exist.