Panasonic NC-PH22WTW / NC-PH30WTW Service Manual ▷ View online
- 13 -
1. Remove 2 screws off.
2. Remove board holder B off. (Pull upside)
3. Pull off lead wire assy E.
4. Remove LED holder off.
5. Lean board holder B claw and pull control
unit B to remove.
2. Remove board holder B off. (Pull upside)
3. Pull off lead wire assy E.
4. Remove LED holder off.
5. Lean board holder B claw and pull control
unit B to remove.
4.6 Control unit B comp.
FIG. 7
FIG. 6
Operating point
When remove board holder B, please do in 1
set in order to not forget Seal packing F.
set in order to not forget Seal packing F.
Tapping screw
(M3.5 x 12)
(2 pcs)
Board holder B
LED holder
Lead wire
assy E
assy E
Control unit B
Seal packing F
Board holder B
Claw
NC-PH22, NC-PH30
- 14 -
4.7 How to remove Decoration
panel (Display Part)
panel (Display Part)
Open (A point) with minus screwdriver of small
pin.
pin.
FIG. 8
FIG. 9
4.8 Peg frame
1. Remove body follow the instruction.
2. Remove bottom ring upside with minus
screwdriver or etc.
3. Remove 1 screw off.
4. Use minus screwdriver to pry between 2 ribs
of peg frame and body, and then push out
peg frame with thumb, then pull it off.
2. Remove bottom ring upside with minus
screwdriver or etc.
3. Remove 1 screw off.
4. Use minus screwdriver to pry between 2 ribs
of peg frame and body, and then push out
peg frame with thumb, then pull it off.
FIG. 9
Bottom ring
Peg frame
Tapping screw
(M4 x 12)
(M4 x 12)
Minus
screwdriver
screwdriver
4
NC-PH22, NC-PH30
- 15 -
Press clear part of gauge cover from inner
body by thumb and remove it.
body by thumb and remove it.
4.9 Gauge cover
1. Remove 4 screws off.
2. Remove Inner lid off.
2. Remove Inner lid off.
4.10 Lid comp. and Inner Lid
FIG. 11
FIG. 10
Body
Push by thumb
Gauge cover
Tapping screws (M4 x 10)
Inner lid
Packing A
Seal packing B
Lid comp.
NC-PH22, NC-PH30
- 16 -
4.11 Lid packing and Steam way A
1. Remove steam way A.
2. Remove lid packing.
2. Remove lid packing.
FIG. 12
FIG. 13
4.12 Lid and Pump comp.
1. Remove 4 screws off.
2. Use minus screwdriver to pry between lid
and pump comp.
2. Use minus screwdriver to pry between lid
and pump comp.
Steam way A
Lid packing
Tapping screw
(M4 x 10)
(M4 x 10)
Pump comp.
Lid
NC-PH22, NC-PH30
Click on the first or last page to see other NC-PH22WTW / NC-PH30WTW service manuals if exist.