JBL RADIAL (serv.man5) EMC - CB Certificate ▷ View online
Page 4 of 49
Report No. 152949
TRF No. IEC60950_1B
Summary of compliance with National Differences
All CENELEC members according to EN 60950-1:2006/A11:2009/A1:2010
All CB members as listed in the IECEE Online Bulletin.
Israel: Test results according to SI 60950:2000.
Singapore: Consumer Protection Information Booklet, 2002 Edition, (Ver. 3).
At the time of issuing this report, not all countries are listed for IEC 60950-1:2005 (ed.2). Therefore this
report includes National Differences for IEC 60950-1:2005 (ed.2), IEC 60950-1:2001 (ed.1) and
IEC 60950:1999 (ed.3).
All National differences listed in the CB Bulletin are covered by the Common Modifications, Special
National Conditions, National Differences, and the National Requirements noted above except for the
following countries which are documented in National Differences Appendixes attached to this report.
Israel: Test results according to SI 60950:2000.
Singapore: Consumer Protection Information Booklet, 2002 Edition, (Ver. 3).
At the time of issuing this report, not all countries are listed for IEC 60950-1:2005 (ed.2). Therefore this
report includes National Differences for IEC 60950-1:2005 (ed.2), IEC 60950-1:2001 (ed.1) and
IEC 60950:1999 (ed.3).
All National differences listed in the CB Bulletin are covered by the Common Modifications, Special
National Conditions, National Differences, and the National Requirements noted above except for the
following countries which are documented in National Differences Appendixes attached to this report.
China: Deviations to published
IEC Documents.
Japan: Deviations to published
IEC Documents.
Ukraine: Deviations to published
IEC Documents.
IEC Documents.
Japan: Deviations to published
IEC Documents.
Ukraine: Deviations to published
IEC Documents.
List from IEC 60950-1 (ed.1):
Countries listed in the IECEE
Online CB Bulletin as follows:
Argentina (AR), Austria (AT),
Australia (AU), Belgium (BE),
Canada (CA), Switzerland (CH),
China (CN), Germany (DE),
Denmark (DK), Finland (FI),
France (FR), United Kingdom
(GB), Greece (GR), Hungary
(HU), Israel (IL), India (IN), Italy
(IT), Japan (JP), Kenya (KE),
Korea (KR), Malaysia (MY),
Netherlands (NL), Norway (NO),
Poland (PL), Sweden (SE),
Singapore (SG), Slovenia (SI),
Slovakia (SK), United States
(US).
Countries listed in the IECEE
Online CB Bulletin as follows:
Argentina (AR), Austria (AT),
Australia (AU), Belgium (BE),
Canada (CA), Switzerland (CH),
China (CN), Germany (DE),
Denmark (DK), Finland (FI),
France (FR), United Kingdom
(GB), Greece (GR), Hungary
(HU), Israel (IL), India (IN), Italy
(IT), Japan (JP), Kenya (KE),
Korea (KR), Malaysia (MY),
Netherlands (NL), Norway (NO),
Poland (PL), Sweden (SE),
Singapore (SG), Slovenia (SI),
Slovakia (SK), United States
(US).
Australia (including New
Zealand): Deviations to
published IEC Documents.
Zealand): Deviations to
published IEC Documents.
List from IEC 60950-1 (ed.2):
Countries listed in the IECEE
Online CB Bulletin as follows:
Austria (AT), Switzerland (CH),
Germany (DE), Denmark (DK),
Spain (ES), Finland (FI), France
(FR), United Kingdom (GB),
Ireland (IE), Italy (IT), Japan
(JP), Korea (KR), Netherlands
(NL), Norway (NO), Poland (PL),
Sweden (SE), Slovenia (SI).
Countries listed in the IECEE
Online CB Bulletin as follows:
Austria (AT), Switzerland (CH),
Germany (DE), Denmark (DK),
Spain (ES), Finland (FI), France
(FR), United Kingdom (GB),
Ireland (IE), Italy (IT), Japan
(JP), Korea (KR), Netherlands
(NL), Norway (NO), Poland (PL),
Sweden (SE), Slovenia (SI).
Canada: Deviations to published
IEC Documents.
Korea: Deviations to published
IEC Documents.
United States: Deviations to
published IEC Documents.
IEC Documents.
Korea: Deviations to published
IEC Documents.
United States: Deviations to
published IEC Documents.
Page 5 of 49
Report No. 152949
TRF No. IEC60950_1B
Copy of marking plate
The artwork below may be only a draft. The use of certification marks on a product must be authorized
by the respective NCBs that own these marks.
by the respective NCBs that own these marks.
(Additional requirements for markings. See 1.7 NOTE)
Page 6 of 49
Report No. 152949
TRF No. IEC60950_1B
Test item particulars ................................................... :
Equipment mobility..................................................... : [X] movable [] hand-held [] transportable
[] stationary [] for building-in [] direct plug-in
Connection to the mains ............................................ : [] pluggable equipment [] type A [] type B
[] permanent connection
[] detachable power supply cord
[] non-detachable power supply cord
[X] not directly connected to the mains
[] detachable power supply cord
[] non-detachable power supply cord
[X] not directly connected to the mains
Operating condition .................................................... : [X] continuous
Normal load:
Max. Undistorted with sign wave signal was 4 W,
reduced to 1/8th Max. with filtered pink noise per
IEC/EN 60065 for maximum normal load.
Refer to Summary of Testing.
[] rated operating / resting time:
Max. Undistorted with sign wave signal was 4 W,
reduced to 1/8th Max. with filtered pink noise per
IEC/EN 60065 for maximum normal load.
Refer to Summary of Testing.
[] rated operating / resting time:
Access location ......................................................... : [X] operator accessible
[] restricted access location
Over voltage category (OVC) ................................... : [X] OVC I [] OVC II [] OVC III [] OVC IV
[] other:
Mains supply tolerance (%) or absolute mains
supply values ............................................................ :
supply values ............................................................ :
N/A
Tested for IT power systems .................................... : [] Yes [X] No
IT testing, phase-phase voltage (V) .......................... : N/A
Class of equipment ................................................... : [] Class I [] Class II [X] Class III
[] Not classified
Considered current rating of protective device as
part of the building installlation (A) ........................... :
part of the building installlation (A) ........................... :
N/A
Pollution degree (PD) ............................................... : [] PD 1 [X] PD 2 [] PD 3
IP protection class .................................................... : Minimum IP 20 (not evaluated for ingress of water)
Altitude during operation (m) .................................... : Normal Home and office <2000m
Altitude of test laboratory (m) .................................... : 10m, sea level
Mass of equipment (kg) ............................................ : 2.2 kg (representative of all models)
Dimension: 30.5mm diameter by 27mm tall
Possible test case verdicts:
- test case does not apply to the test object ................. : N/A (or N)
- test object does meet the requirement....................... : P (Pass)
- test object does not meet the requirement ................ : F (Fail)
Testing .......................................................................... :
Date of receipt of test item ............................................ : 2010-06
Date(s) of performance of tests .................................... : 2010-06 – 2010-07
Page 7 of 49
Report No. 152949
TRF No. IEC60950_1B
General remarks:
The test results presented in this report relate only to the object tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
"(see Enclosure #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a
This report shall not be reproduced, except in full, without the written approval of the Issuing testing
laboratory.
"(see Enclosure #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a
comma /
point is used as the decimal separator.
Manufacturer’s Declaration per sub-clause 6.2.5 of IECEE 02:
The application for obtaining a CB Test Certificate
includes more than one factory location and a
declaration from the Manufacturer stating that the
sample(s) submitted for evaluation is (are)
representative of the products from each factory has
been provided ................................................................:
includes more than one factory location and a
declaration from the Manufacturer stating that the
sample(s) submitted for evaluation is (are)
representative of the products from each factory has
been provided ................................................................:
Yes
Not applicable
When differences exist; they shall be identified in the General product information section.
Name and address of factory (ies) .......................... :
Guoguang Electric Co. Ltd.
No. 8 Jinghu Road, Xinhua Street
Huadu Region, Guangzhou,
510800 P.R. China
No. 8 Jinghu Road, Xinhua Street
Huadu Region, Guangzhou,
510800 P.R. China
Click on the first or last page to see other RADIAL (serv.man5) service manuals if exist.