DOWNLOAD JBL ON STAGEII (serv.man6) Service Manual ↓ Size: 1.72 MB | Pages: 72 in PDF or view online for FREE

Model
ON STAGEII (serv.man6)
Pages
72
Size
1.72 MB
Type
PDF
Document
EMC - CB Certificate
Brand
Device
Audio
File
on-stageii-sm6.pdf
Date

JBL ON STAGEII (serv.man6) EMC - CB Certificate ▷ View online

Nemko USA, Inc. 
11696 Sorrento Valley Road, Suite F, San Diego, CA  92121 
Phone (858) 755-5525  Fax (858) 452-1810 
DATE 
DOCUMENT NAME 
DOCUMENT # 
PAGE 
Janurary 5,2006 
Harman Multimedia  OnStage UD    CE Test Report 
2006 011114 CE AUS/NZ 
 
13 of 72 
 
 
Figure 1.   General EUT Test Setup Diagram 
 
 
 
 
 
 
N
OT TO 
S
CALE
 
CONFIGURATION LEGEND 
 
1.  Non-Conducting tables 80 cm above ground plane 
2.  Support - I-Pod  
3.  EUT: Computer Speaker System 
4.  Support- Leader Power Supply 
 
 
3
Nemko USA, Inc. 
11696 Sorrento Valley Road, Suite F, San Diego, CA  92121 
Phone (858) 755-5525  Fax (858) 452-1810 
DATE 
DOCUMENT NAME 
DOCUMENT # 
PAGE 
Janurary 5,2006 
Harman Multimedia  OnStage UD    CE Test Report 
2006 011114 CE AUS/NZ 
 
14 of 72 
 
 
 
Nemko USA, Inc. 
11696 Sorrento Valley Road, Suite F, San Diego, CA  92121 
Phone (858) 755-5525  Fax (858) 452-1810 
DATE 
DOCUMENT NAME 
DOCUMENT # 
PAGE 
Janurary 5,2006 
Harman Multimedia  OnStage UD    CE Test Report 
2006 011114 CE AUS/NZ 
 
15 of 72 
 
 
 
Nemko USA, Inc. 
11696 Sorrento Valley Road, Suite F, San Diego, CA  92121 
Phone (858) 755-5525  Fax (858) 452-1810 
DATE 
DOCUMENT NAME 
DOCUMENT # 
PAGE 
Janurary 5,2006 
Harman Multimedia  OnStage UD    CE Test Report 
2006 011114 CE AUS/NZ 
 
16 of 72 
 
3.2.  Configuration and Methods of Measurements for Conducted Emissions 
 
EN 55022 specifies the general configuration of the EUT and associated equipment, as well as the test 
platform for conducted emissions testing.  
Tabletop 
devices are placed on a non-conducting surface 80 
centimeters above the ground plane and 40 centimeters from a vertical ground plane wall.  The EUT was 
powered via an Artificial Mains Network (AMN).  Both quasi-peak and average detector measurement modes 
are used.  If however, the average limit is met while using a quasi-peak detector, the test unit is deemed to 
meet both the limits, and measurement with the average detector receiver is unnecessary.  The quasi-peak and 
average emission levels are then recorded and compared to the applicable EN 55022 limits to determine 
compliance. 
 
Page of 72
Display

Click on the first or last page to see other ON STAGEII (serv.man6) service manuals if exist.