JBL DUET 200 (serv.man3) EMC - CB Certificate ▷ View online
- Page 53 of 62 -
Report
No. 111798
IEC 60950-1:2005 / EN 60950-1:2006
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IECEN60950_1C
2.1.1.5 c1) TABLE: max. V, A, VA test
N
Voltage (rated)
(V)
Current (rated)
(A)
Voltage (max.) (V) Current (max.) (A
VA (max.)
(VA)
supplementary information:
The above measurements are the maximum values (max. V and max. A not obtained at the same time).
2.1.1.5 c2) TABLE: stored energy
N
Capacitance C (µF)
Voltage U (V)
Energy E (J)
supplementary information:
- Page 54 of 62 -
Report
No. 111798
IEC 60950-1:2005 / EN 60950-1:2006
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IECEN60950_1C
2.2
TABLE: evaluation of voltage limiting components in SELV circuits
N
Component (measured between)
max. voltage (V)
(normal operation)
Voltage Limiting Components
V peak
V d.c.
Fault test performed on voltage limiting components
Voltage measured (V) in SELV circuits
(V peak or V d.c.)
supplementary information:
S-c = Short circuit
2.4.2
Limited current circuit measurement
N
Location :
Condition
Voltage
(V)
Current
(mA)
Freq.
(kHz)
Limit
(mA)
Comments
supplementary information:
- Page 55 of 62 -
Report
No. 111798
IEC 60950-1:2005 / EN 60950-1:2006
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IECEN60950_1C
2.5
TABLE: limited power sources
N
Circuit output tested: See below
Measured Uoc (V) with all load circuits
disconnected: See below
disconnected: See below
I
sc
(A)
VA
Measuring position
Meas.
Limit
Meas.
Limit
supplementary information:
2.10.2
TABLE: determination of operating voltage measurement
⎯
Location
Component
From
To
Peak Voltage (Vac) RMS Voltage (Vac) Comments
supplementary information:
2.10.3 and
2.10.4
2.10.4
TABLE: Clearance and creepage distance measurements
N
Clearance (cl) and creepage
distance (cr) at/of/between:
distance (cr) at/of/between:
U peak (V)
U r.m.s.
(V)
Required cl
(mm)
cl
(mm)
Required cr
(mm)
cr
(mm)
supplementary information:
- Page 56 of 62 -
Report
No. 111798
IEC 60950-1:2005 / EN 60950-1:2006
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IECEN60950_1C
Copy of PCB, layout of tracing (not to scale):
2.10.5
TABLE: Distance through insulation measurements
N
Distance through insulation (DTI) at/of:
U peak
(V)
U rms
(V)
Test volt-
age
(Vac)
Required DTI
(mm)
DTI
(mm)
supplementary information:
Click on the first or last page to see other DUET 200 (serv.man3) service manuals if exist.