DOWNLOAD Harman Kardon AVR 171 (serv.man5) Service Manual ↓ Size: 6.35 MB | Pages: 108 in PDF or view online for FREE

Page 12 of 16 

Report No.: 232174 

 

ATTACHMENT 4 

Clause 

Requirement + Test 

Result - Remark 

Verdict 

 

TRF No. IEC60065K 
 

5.3 
(A2:2010) 

Finland, Norway and Sweden 
To the end of the subclause the following is added:

CLASS I 

apparatus which is intended for connection 

to the building installation wiring 
via a plug or an appliance coupler, or both and in 
addition is intended for connection 
to other apparatus or a network shall, if safety 
relies on connection to protective earth 
or if surge suppressors are connected between the 
network 

TERMINALS 

and 

ACCESSIBLE 

parts, have a marking stating that the 

apparatus must be connected to an 
earthed 

MAINS 

socket-outlet. 

The marking text in the applicable countries shall 
be as follows: 
In Finland: "Laite on liitettävä suojakoskettimilla 
varustettuun pistorasiaan" 
In Norway: “Apparatet må tilkoples jordet 
stikkontakt” 
In Sweden: “Apparaten skall anslutas till jordat 
uttag” 

Class II apparatus. 

5.4 
(A11:2008) 
 

Finland, Norway and Sweden 
To the end of 5.4 the following is added: 
CLASS I apparatus which is intended for 
connection to the building installation wiring via a 
plug or an appliance coupler, or both and in 
addition is intended for connection to other 
apparatus or a network shall, if safety relies on 
connection to protective earth or if surge 
suppressors are connected between the network 
TERMINALS and ACCESSIBLE parts, have a 
marking stating that the apparatus must be 
connected to an MAINS socket-outlet with 
protective earth. 
The marking text in the applicable countries shall 
be as follows: 
In Finland: “Laite on liitettävä 
suojamaadoituskoskettimilla varustettuun 
pistorasiaan” 
In Norway: “Apparatet må tilkoples jordet 
stikkontakt” 
In Sweden: "Apparaten skall anslutas till jordat 
uttag" 

Class II apparatus. 

Page 13 of 16 

Report No.: 232174 

 

ATTACHMENT 4 

Clause 

Requirement + Test 

Result - Remark 

Verdict 

 

TRF No. IEC60065K 
 

5.4.1 
(A11:2008) 

Norway and Sweden  
To the end of 5.4.1 (after the compliance 
statement) the following is added:  
The screen of the cable distribution system is 
normally not earthed at the entrance of the building 
and there is normally no equipotential bonding 
system within the building. Therefore the protective 
earthing of the building installation need to be 
isolated from the screen of a cable distribution 
system.  
It is however accepted to provide the insulation 
external to the equipment by an adapter or an 
interconnection cable with galvanic isolator, which 
may be provided by e.g. a retailer.  
The user manual shall then have the following or 
similar information in Norwegian and Swedish 
language respectively, depending on in what 
country the equipment is intended to be used in:  
“Equipment connected to the protective earthing of 
the building installation through the mains 
connection or through other equipment with a 
connection to protective earthing – and to a cable 
distribution system using coaxial cable, may in 
some circumstances create a fire hazard. 
Connection to a cable distribution system has 
therefore to be provided through a device providing 
electrical isolation below a certain frequency range 
(galvanic isolator, see EN 60728-11)”  

NOTE In Norway, due to regulation for installations of cable 
distribution systems, and in Sweden, a galvanic isolator shall 
provide electrical insulation below 5 MHz. The insulation shall 
withstand a dielectric strength of 1,5 kV r.m.s., 50 Hz or 60 Hz, 
for 1 min.  

Translation to Norwegian (the Swedish text will also 
be accepted in Norway):  
“Utstyr som er koplet til beskyttelsesjord via 
nettplugg og/eller via annet jordtilkoplet utstyr – og 
er tilkoplet et kabel-TV nett, kan forårsake 
brannfare. For å unngå dette skal det ved tilkopling 
av utstyret til kabel-TV nettet installeres en 
galvanisk isolator mellom utstyret og kabel-TV 
nettet.”  
Translation to Swedish:  
”Utrustning som är kopplad till skyddsjord via jordat 
vägguttag och/eller via annan utrustning och 
samtidigt är kopplad till kabel-TV nät kan i vissa fall 
medföra risk för brand.  
Főr att undvika detta skall vid anslutning av 
utrustningen till kabel-TV nät galvanisk isolator 
finnas mellan utrustningen och kabel-TV nätet.” 

No CDS 

Page 14 of 16 

Report No.: 232174 

 

ATTACHMENT 4 

Clause 

Requirement + Test 

Result - Remark 

Verdict 

 

TRF No. IEC60065K 
 

13.3.1 

NO: To the second paragraph the following is 
added: 
In Norway, due to the IT power distribution system 
used, the a.c. MAINS supply voltage is considered 
to be equal to the line-to-line voltage, and will 
remain 230 V in case of a single earth fault. 
Justification: Based on a use in Norway of an IT 
power distribution system where the neutral is not 
provided. 

Noted. 

15.1.1 
(A11:2008)

 

Denmark  
The text of the Danish SNC in EN 60065:2002 has 
been modified as follows:  
To the first paragraph the following is added:  
In Denmark, supply cords of single-phase 
appliances having a rated current not exceeding 13 
A shall be provided with a plug according to the 
Heavy Current Regulations Section 107-2-D1.  
Appliances of CLASS I provided with socket-outlets 
with earth contact or which are intended to be used 
in locations where protection against indirect 
contact is required according to the wiring rules 
shall be provided with a plug in accordance with the 
Heavy Current Regulations, Section 107-2-D1 
standard sheet DK 2-1a.  
To the second paragraph the following is added:  
Socket outlets intended for providing power to 
CLASS II apparatus with a rated current of 2,5 A 
shall be in accordance with the Heavy Current 
Regulation, Section 107-2-D1 standard sheet DKA 
1-4a.  
Other current ratings socket outlets shall be in 
compliance with the Heavy Current Regulation, 
Section 107-2-D1 standard sheet DKA 1-3a or DKA 
1-3b.  
To the third paragraph the following is added:  
Mains socket-outlets with earthing contact shall be 
in compliance with the Heavy Current Regulation, 
Section 107-2-D1 standard sheet DK 1-3a, DK 1-5a 
or DK 1-7a.  
Justification: Heavy Current Regulations, Section 
107-2-D1 

No socket-outlets. 
Plug with supply cord for DK 
not provided. 
See summary of testing. 

15.1.1 

IE: Apparatus which is fitted with a flexible cable or 
cord shall be provided with a 13 A plug in 
accordance with Statutory Instrument 525:97, “13 A  
Plugs and Conversion Adapters for Domestic Use 
Regulations:1997. 

Justification: SI 525: 1997

Not provided. 
See summary of testing. 

Page 15 of 16 

Report No.: 232174 

 

ATTACHMENT 4 

Clause 

Requirement + Test 

Result - Remark 

Verdict 

 

TRF No. IEC60065K 
 

15.1.1 

NO: Mains socket-outlets mounted on CLASS II 
apparatus shall comply with the specifications 
given in CEE Publ. 7 as far as a applicable, with 
the following amendments: 
§ 8 Dimensions 
a 2.5 A 250 V two-pole socket-outlets for electronic 
apparatus shall comply with the enclosed Standard 
Sheet I. 

 

§ 24 Mechanical strength 
A 2,5 A 250 V socket-outlets for CLASS II 
electronic apparatus are tested as specified in 
12.1.3 of EN 60065. Also the protecting rim shall be 
tested 
Justification: Act of 24 May 1929 relating to 
supervision of electrical installation (TEA 1929/FEL 
1998). 

No mains socket-outlets 

15.1.1  

UK: Apparatus which is fitted with a flexible cable 
or cord and is designed to be connected to a mains 
socket conforming to BS 1363 by means of that 
flexible cable or cord and plug shall be fitted with 
a ”standard plug” in accordance with Statutory 
Instrument 1768: 1994: The Plugs and Sockets etc. 
(Safety) Regulations 1994, unless exempted by 
those Regulations. 
NOTE ”Standard plug” is defined in SI 1768:1994 
and essentially means an approved plug 
conforming to BS 1363 or an approved conversion 
plug. 
Justification: SI 1768: 1994 

Considered. 
See appended table, list of 
critical components.