Harman Kardon AVR 171 (serv.man5) EMC - CB Certificate ▷ View online
Page 4 of 5
Report No.: 232174
ATTACHMENT 5
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Applicable to portable/wall socket-outlet and portable cable reel
20 Portable/wall
socket-outlet
and portable
cable reel
and portable
cable reel
a) If residual current device (RCD) is
incorporated, its tripping current must
be less than 30mA and operating
time must be less than 0.1 second
and testing to sub-clauses 9.9.2.1,
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
b) The shutters screening the current-
carrying socket contacts shall not be
opened by the insertion of any
corresponding SINGLE pin of the
plug into any current-carrying socket
aperture.
incorporated, its tripping current must
be less than 30mA and operating
time must be less than 0.1 second
and testing to sub-clauses 9.9.2.1,
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
b) The shutters screening the current-
carrying socket contacts shall not be
opened by the insertion of any
corresponding SINGLE pin of the
plug into any current-carrying socket
aperture.
No portable/wall socket-
outlet and portable cable
reel.
outlet and portable cable
reel.
N/A
21
Wall switched
socket-outlet
(2 x single
socket-outlet)
socket-outlet
(2 x single
socket-outlet)
Single socket-outlet with 2-gang
faceplate/frame must be fulfilled
with the test requirements as 2-gang
socket-outlet.
faceplate/frame must be fulfilled
with the test requirements as 2-gang
socket-outlet.
N/A
22
Remote
controlled
portable/wall
portable
socket-outlet
controlled
portable/wall
portable
socket-outlet
Remote controlled portable/wall
socket-outlet shall not be
allowed for registration.
socket-outlet shall not be
allowed for registration.
N/A
Applicable to roaster
23
Roaster
A metal ring (Appendix U) must be
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
No roaster
N/A
Applicable to Residual Current Circuit Breaker (RCCB)
33 RCCB
Registration of RCCB is limited to 30
mA sensitivity and the operating time
must be less than 0.1 second.
Electronic RCCB will not be accepted
for registration.
mA sensitivity and the operating time
must be less than 0.1 second.
Electronic RCCB will not be accepted
for registration.
No residual current circuit
breaker
breaker
N/A
Applicable to electric instantaneous and storage water heater
34
Instantaneous
electric water
heater and mains
pressure electric
storage water
heater
electric water
heater and mains
pressure electric
storage water
heater
Heating elements used must not
be of the "bare-element" type.
be of the "bare-element" type.
No electric instantaneous
and storage water heater
and storage water heater
N/A
Page 5 of 5
Report No.: 232174
ATTACHMENT 5
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
35
Water heater
incorporated with
residual current
device(RCD)
incorporated with
residual current
device(RCD)
Testing to sub-clauses 9.9.2.1,
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
N/A
Applicable to multiway adaptor
36 Multiway
adaptor
with 3-pin socket-
outlets or
combination of 3-
pin and 2-pin
socket-outlets
outlets or
combination of 3-
pin and 2-pin
socket-outlets
a) The socket contacts of the
adaptor shall only accept 13A 3-pin
mains plug complying with SS 145
and/or 2.5A 2-pin mains plug
complying with EN 50075.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the
insertion of any corresponding
SINGLE pin of the plug into any
current-carrying socket aperture.
c) A barrier or other acceptable
means shall be provided on the
engagement surface of the 2.5A 2-
pin socket-outlet of the adaptor to
PREVENT entry of any types of 2-
pin mains plugs except those
complying with EN 50075. (note:
shutters cannot be regarded as
barriers)
d) Adaptor incorporates with switch
would require additional test to
sub-clauses 13.11, 17.1.3 and
18.1.3 of SS 145: Part 2: 1997.
adaptor shall only accept 13A 3-pin
mains plug complying with SS 145
and/or 2.5A 2-pin mains plug
complying with EN 50075.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the
insertion of any corresponding
SINGLE pin of the plug into any
current-carrying socket aperture.
c) A barrier or other acceptable
means shall be provided on the
engagement surface of the 2.5A 2-
pin socket-outlet of the adaptor to
PREVENT entry of any types of 2-
pin mains plugs except those
complying with EN 50075. (note:
shutters cannot be regarded as
barriers)
d) Adaptor incorporates with switch
would require additional test to
sub-clauses 13.11, 17.1.3 and
18.1.3 of SS 145: Part 2: 1997.
No multiway adaptor
N/A
Applicable to plasma/LCD display monitor
37 Plasma/LCD
display monitor
with TV tuner
with TV tuner
Plasma/LCD display monitor tested
to IEC 60950 would require
additional test to clauses 9 (related
to antenna only), 10.1, 10.2, 10.3
and 12.5 of IEC 60065.
to IEC 60950 would require
additional test to clauses 9 (related
to antenna only), 10.1, 10.2, 10.3
and 12.5 of IEC 60065.
No Plasma/LCD display
monitor
monitor
N/A
Page 1 of 6
Report No.: 232174
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
CHINA NATIONAL DIFFERENCES
Test results according to Online CB BULLETIN (Last modification date of 2012-06-06)
Differences according .................... : IEC 60065, 7th edition (2001)+Amendment 1 (2005)
Corresponding National Standard GB 8898-2011
No.
Requirement – Test
Result - Remark
Verdict
1.1.3
Amended the first paragraph:
This standard applies to apparatus intended to be
used basically at altitudes not exceeding 5 000 m,
dry climate at warm temperate zone or tropical
climates.
This standard applies to apparatus intended to be
used basically at altitudes not exceeding 5 000 m,
dry climate at warm temperate zone or tropical
climates.
Noted
The fourth paragraph replaced by following:
For apparatus intended to be used in vehicles,
ships or aircraft, or at altitudes exceeding
5 000m, additional requirements may be necessary.
For apparatus intended to be used in vehicles,
ships or aircraft, or at altitudes exceeding
5 000m, additional requirements may be necessary.
The apparatus intended to be
operated at altitudes up to
2 000m.
operated at altitudes up to
2 000m.
N/A
5
At the end of the first paragraph ,added following:
For apparatus intended to be used at altitude not
exceeding 2000m, a warning label containing the
following or a similar appropriate wording or a
symbol as in annex R(see following) shall fixed to
the equipment at readily visible place.
"Only used at altitude not exceeding 2000m."
For apparatus intended to be used at altitude not
exceeding 2000m, a warning label containing the
following or a similar appropriate wording or a
symbol as in annex R(see following) shall fixed to
the equipment at readily visible place.
"Only used at altitude not exceeding 2000m."
If only symbol used, the explanation of the symbol
shall be contained in the instruction manual.
shall be contained in the instruction manual.
The apparatus intended to
be operated at altitudes up to
2 000m, and a
be operated at altitudes up to
2 000m, and a
ppropriate
wording provided as follows,
See copy of marking plate.
P
Page 2 of 6
Report No.: 232174
ATTACHMENT 6
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
For apparatus intended to be used in not-tropical
climate regions, a warning label containing the
following or a similar appropriate wording or a
symbol as in annex R shall fixed to the equipment
at readily visible place.
"Only used in not-tropical climate regions."
climate regions, a warning label containing the
following or a similar appropriate wording or a
symbol as in annex R shall fixed to the equipment
at readily visible place.
"Only used in not-tropical climate regions."
If only symbol used, the explanation of the symbol
shall be contained in the instruction manual.
The statements above shall be given in a language
acceptable to the regions where the apparatus is
intended to be used.
shall be contained in the instruction manual.
The statements above shall be given in a language
acceptable to the regions where the apparatus is
intended to be used.
The apparatus intended to
be used in not tropical climate
regions, and a
be used in not tropical climate
regions, and a
ppropriate
wording provided as follows
See copy of marking plate.
P
5.1 e)
After the last paragraph, added:
…….For single rated voltage, “220 V” or three-
phase “380V” shall be marked only. For a rating
range, 220 V or three-phase 380V shall be covered.
For multiple rated voltages, one of them shall be
220 V or three-phase 380V and which default
setting from manufacture shall be 220 V or three-
phase 380V as well.
…….For single rated voltage, “220 V” or three-
phase “380V” shall be marked only. For a rating
range, 220 V or three-phase 380V shall be covered.
For multiple rated voltages, one of them shall be
220 V or three-phase 380V and which default
setting from manufacture shall be 220 V or three-
phase 380V as well.
Covered
P
5.1 f)
After the first sentence, Added:
……for Rated MAINS frequency or frequency range
shall be 50Hz or covered 50Hz.
……for Rated MAINS frequency or frequency range
shall be 50Hz or covered 50Hz.
Rated MAINS frequency of
50Hz covered.
50Hz covered.
P
5.4
Replaced the second sentence of the first
paragraph:
This information shall be given in normative
Chinese.
paragraph:
This information shall be given in normative
Chinese.
Adequate instruction supplied
by Chinese manual with the
apparatus.
by Chinese manual with the
apparatus.
P
5.4.1i)
Added new paragraph i),after the h) paragraph:
i) For apparatus incorporating antenna coaxial
sockets witch is non-separated with CATV network,
a warning wording or a similar shall be given in the
instructions manual:
“The CATV network connecting to this apparatus
shall separate from protective earth, otherwise it
may cause fire or other hazard.”
i) For apparatus incorporating antenna coaxial
sockets witch is non-separated with CATV network,
a warning wording or a similar shall be given in the
instructions manual:
“The CATV network connecting to this apparatus
shall separate from protective earth, otherwise it
may cause fire or other hazard.”
No CDS
N/A
Click on the first or last page to see other AVR 171 (serv.man5) service manuals if exist.