Sony KDL-46HX855 / KDL-55HX855 Service Manual ▷ View online
KDL-46HX855/55HX855 16
SECTION 3 - FLOW CHARTS AND DIAGRAMS
NO 3D VIEWING
LOCATED ON LOWER BEZEL NEAR SONY LOGO
3D Not Working
Use video or still
camera to view IR
LED’s on IR
transmitter
IR LED’s lighting?
No
Double images
displayed on
screen?
Yes
Main Board*
No
Yes
Press “3D” button on
remote commander
and select
“Simulated 3D”
SYNC EMITTER
LED’s
Shutter Glasses
View image with
known working
pair of shutter
glasses.
Double images
become one?
Yes
3D OK
No
3D IR Emitter
Board*
NO 3D FLOWCHART
*For Part Number information, Refer to
“Section 4 - Disassembly/Part Number Information” on page 17
.
KDL-46HX855/55HX855
17
Components not identified by a part number or
description are not stocked because they are seldom
required for routine service.
The component parts of an assembly are indicated by the
reference numbers in the far right column of the parts list
and within the dotted lines of the diagram.
*
Items marked with an asterisk are not stocked since
they are seldom required for routine service. Expect
some delay when ordering these components.
NOTE: The components identified by shading
and
!
mark are critical for safety. Replace only
with part number specified.
NOTE: The components identified by a red outline and a mark contain
confidential information. Specific instructions must be adhered to whenever
these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
TABLE-TOP STAND REMOVAL
A
Remove 3 screws from the Table-Top Stand, then lift up the LCD TV and gently place it face down onto a soft cloth.
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
1
A-1877-603-A
STAND,HEAD BLOCK (MLG)
2
4-400-778-01
STAND, NECK T. S (46ML)
(KDL-46HX855 ONLY)
2
4-400-779-01
STAND, NECK T. S (2L)
(KDL-55HX855 ONLY)
3
A-1877-604-A
STAND,BASE BLOCK (MLG)
(KDL-46HX855 ONLY)
3
A-1877-606-A
STAND,BASE BLOCK (2LG)
(KDL-55HX855 ONLY)
▲
2-580-608-01
SCREW, +PSW M5X16
(SCREWS TO ATTACH TABLE-TOP STAND TO LCD TV)
For product protection and safety reasons, Sony strongly recommends
that you use the screws provided with the TV.
CAUTION: These screws cannot be used to secure the TV to the Wall
Mount Brackets.
1
COVER, ARM L
3
2
COVER, ARM R
Soft Cloth
A
KDL-46HX855/55HX855
18
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
NOTE: The components identified by shading
and
!
mark are critical for safety. Replace only
with part number specified.
NOTE: The components identified by a red outline and a mark contain
confidential information. Specific instructions must be adhered to whenever
these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
REAR COVER REMOVAL
REAR COVER CAUTION
The Rear Cover for these models has some sharp edges.
KDL-46HX855 Only
Refer to the following illustration when handling the Rear Cover.
Areas with red
have sharp
edges and are
Not reinforced.
Use Caution with
these areas to
avoid damaging
the Rear Cover.
Areas with
yellow have
sharp edges.
Use Caution
with these
areas.
Handle the
Rear Cover
using these
areas.
KDL-55HX855 Only
Refer to the following illustration when handling the Rear Cover.
Areas with red
have sharp
edges and are
Not reinforced.
Use Caution with
these areas to
avoid damaging
the Rear Cover.
Areas with
yellow have
sharp edges.
Use Caution
with these
areas.
Handle the
Rear Cover
using these
areas.
CAUTIONS:
The Rear Cover for these models has sharp edges, use gloves or a cloth for protection against the sharp edges.
Do not lift the Rear Cover from the bottom side, lifting the Rear Cover from the bottom side will deform and damage
The Rear Cover for these models has sharp edges, use gloves or a cloth for protection against the sharp edges.
Do not lift the Rear Cover from the bottom side, lifting the Rear Cover from the bottom side will deform and damage
the Rear Cover.
Follow the instructions below when removing the Rear Cover.
Follow the instructions below when removing the Rear Cover.
NOTE:
The Side Terminal Label, Rear Terminal Label, Left Rear Terminal Label, Under Terminal Label and Antenna Sheet(G)
The Side Terminal Label, Rear Terminal Label, Left Rear Terminal Label, Under Terminal Label and Antenna Sheet(G)
are not included with the Rear Cover and must be replaced when replacing the Rear Cover.
A
To avoid damaging the AC Power Cord, remove the screw from the AC Cover and disconnect the AC Power
Cord.
Hold the
Power Supply Cord
B
Remove the remaining screws from the Rear Cover.
22 from KDL-46HX855 Only
25 from KDL-55HX855 Only
C
Grasp the Rear Cover from inside the AC Cover opening and lift up. After loosening the bottom left corner
of the Rear Cover, gently begin to lift the Rear Cover towards the top left corner. Then using both hands,
carefully lift-up the left side of the Rear Cover.
D
After loosening the top right corner of the Rear Cover, gently begin to lift the Rear Cover towards the bottom
right corner. Then using both hands, carefully lift-up the right side to detach the Rear Cover.
CATUION:
Lifting from the
bottom side will deform
and damage the Rear Cover
KDL-46HX855/55HX855
19
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
NOTE: The components identified by shading
and
!
mark are critical for safety. Replace only
with part number specified.
NOTE: The components identified by a red outline and a mark contain
confidential information. Specific instructions must be adhered to whenever
these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
REATTACHING THE REAR COVER
A
Align the bottom right corner, then gently insert the rest of the Rear Cover staring with the bottom side first.
Align bottom right corner first
B
Confirm that all of the edges of the Rear Cover have been inserted into the Panel Frame.
Insert Rear Cover
edges into Frame
C
While pushing the bottom side of the Rear Cover towards the top, tighten the screws on the bottom side of the Rear Cover first.
D
Gently hold down the Rear Cover while tightening the remaining screws onto the Rear Cover.
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
51
4-422-627-12
REAR COVER A (46 G)
(KDL-46HX855 ONLY)
51
4-422-626-12
REAR COVER A (55 G)
(KDL-55HX855 ONLY)
52
4-400-427-01
LABEL, SIDE TERMINAL
ORDER THIS PART WHEN REPLACING THE REAR COVER
53
4-400-438-01
LABEL, REAR TERMINAL
ORDER THIS PART WHEN REPLACING THE REAR COVER
54
4-410-866-01
LABEL, REAR TERMINAL LEFT
ORDER THIS PART WHEN REPLACING THE REAR COVER
55
4-400-432-11
LABEL, UNDER TERMINAL
ORDER THIS PART WHEN REPLACING THE REAR COVER
56
4-298-212-01
SHEET, ANT (G)
ORDER THIS PART WHEN REPLACING THE REAR COVER
57
4-297-989-01
AC COVER
!
58
1-846-001-11
CORD, POWER (WITH CONNECTOR)
△
4-268-126-02
SCREW, ORNAMENTAL M6X12
■
7-685-647-79
SCREW, +BVTP 3X10 TYPE2 IT-3
◆
4-400-043-01
JOINT, SCREW
(SCREWS USED WHEN STAND IS ATTACHED -
NOT USED WITH WALL MOUNTS)
◇
4-256-393-01
SCREW, +PSW M3X6 W12
57
51
52
53
54
55
56
58
Click on the first or last page to see other KDL-46HX855 / KDL-55HX855 service manuals if exist.