Sony SAL500F80 Service Manual ▷ View online
4-23
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
3. In case of error display in the ROM Data
1)
When the error display and the NG display appear to the pop up window, press the ENTER key to return to the initial window, and
perform “2. Checking Method” again.
Fig.4-5-4
Fig.4-5-5
2)
If the “NG” appears, confirm or perform the following.
• Cleaning of the signal PC board of main flexible unit or perform the solder.
• Perform or replace the solder of main flexible unit.
3)
Perform “2. Checking Method” again, repeat the inspection until “OK” appears on the pop-up window.
4-24
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
4-6.
FOCUS HOLD BUTTON CHECK (FOCUS HOLD BUTTON INSPECTION)
Equipment
• Personal Computer
• Finished Inspection JIG (AC 100 V only)
• Lens Adjustment Program (ActuatorChecker.exe)
1. Preparations
1)
Connected to equipment with checking lens. (Refer to Section 4-1-3.)
2)
Start up of “ActuatorChecker.exe”.
3)
Click
[Set up]
, and perform the initial setting. (Refer to Section 4-1-4.)
2. Checking Method
1)
Click the
[Focus Hold]
.
Fig.4-6-1
2)
The Serial window appears. Input the lens serial number.
Note:
When
[OK]
is clicked without inputting the serial number, the date executed is displayed on the completion window of each
item.
Fig.4-6-2
3)
The message “Push [FOCUS HOLD] button once softly.” is displayed on the pop-up window.
Press the focus hold button.
Fig.4-6-3
4)
When the focus hold button check finishes normally, “OK” is displayed on the pop-up window.
Fig.4-6-4
4-25
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
3. In case of error display in the Focus Hold Button
1)
When the Focus Hold Button cannot be pressed within a certain period of time or the button is defective, the window below appears.
Fig.4-6-5
2)
In case of error caused by time-out of key pressing, perform the work with caution so as to press the focus hold button within a
certain period of time.
3)
If the “NG” appears, confirm or perform the following.
• Cleaning of the signal PC board of main flexible unit or perform the solder.
• Perform the click plate, and perform or cleaning of the FH pattern of main flexible unit.
• Perform or replace the solder of main flexible unit.
4)
Perform “2. Checking Method”again, repeat the inspection until “OK” appears on the pop-up window.
Revision History
Reverse
SAL500F80 (REFLEX 8/500) (500mm F8 Reflex)
Ver.
1.0
1.1
1.2
1.3
Date
2006.10
2006.12
2007.06
2007.12
History
Official Release
Revised-1
Supplement-1
(S1 DI07-029)
Supplement-2
(S2 DI07-225)
Contents
—
• Change of Repair Parts
(
Section 2
,
Section 3
)
• Change of List of Service Tools and
Equlipments (
Section 4
)
• Change of HELP13
• Change of Repair Parts (
Page 3-1
)
S.M. Rev.
issued
—
Yes
No
Yes
985211414.pdf
