Sony SAL1118 Service Manual ▷ View online
HELP
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
HELP02
Apply grease (G-85) to the gear and shaft of the gear base plate assy.
Grease (G-85): J-6082-626-A
Gear Base Plate Assy
Apply grease (G-85) (all circumference of gear)
Apply grease (G-85) (all circumference of shaft)
HELP
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
HELP03
Adhesive bond (LOCTITE 460) (Note)
Note:
Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Grease (G-15): J-6082-619-A
1.
Apply adhesive bond ((LOCTITE 460) to the back side of the mount index mark, and attach it to the rear lens barrel assy.
2.
Apply grease (G-15) to the instruction portion of the rear lens barrel assy.
3.
Pass the flexible board through the hole on the rear lens barrel assy, and fix the rear lens barrel assy with five screws as shown in the
figure.
Apply grease (G-15) (Side edge)
Apply adhesive bond
(LOCTITE 460)
(Back side)
(LOCTITE 460)
(Back side)
Rear Lens Barrel Assy
Screws
Hole
Flexible Board
Rear Lens Barrel Assy
HELP
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
HELP04
1.
Attach the main pcb assy, and fix it with two screws.
2.
Connect the flexible board to the connector on the main pcb assy.
HELP05
Grease (G-35): J-6082-621-A
Grease (G-85): J-6082-626-A
1.
Apply grease (G-85) to the two instruction portions of the coupler.
2.
Apply grease (G-35) to both sides of the coupler receive.
3.
Pass the coupler to the coupler receive, and fit the shaft of the coupler to the notch of the back adjustment washer(s).
Note:
Be sure to use the gold color one for the back adjustment washer that comes in contact with the coupler.
Flexible Board
Main Pcb Assy
Connector
Apply grease (G-85) (all circumference of gear)
Coupler
Apply grease (G-85) (all circumference of shaft)
Apply grease (G-35) (Both sides)
Coupler Receive
Back Adjustment Washer
HELP
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
HELP06
Note:
About the adhesive sheet in the sentence. When shipping it, Double faced tape (2-886-793-01) is used.
1.
Affix a sheet of the adhesive sheet to the instruction portion of the zoom ring as shown in the figure.
2.
Affix the zoom brush to the adhesive sheet so that tips of the zoom brush contact to the zoom flex patterns.
3.
Perform “4-6. Zoom Brush Position Check/Adjustment and Patter Check”.
4.
Affix the three adhesive sheets to the instruction portions as shown in the figure.
5.
Attach the brush cover as shown in the figure.
Brush Cover
Adhesive Sheet
Zoom Ring
Adhesive Sheet
Zoom Brush
Zoom flex pattern
Click on the first or last page to see other SAL1118 service manuals if exist.