Sony DSC-WX500 Service Manual ▷ View online
4-2-4.
Front Cabinet Section
• Refer to
“5-2-4. Front Cabinet Section”
on exploded view for Ref. No.
(Boss)
(Claw)
(Rib)
(Rib)
Upper Cabinet Section
157
156
155
151
163
158
161
#331
#280
ns
#20
(Note 1)
162
[2]
[1]
[3]
DSC-WX500
4-13
Note 1
(Claws)
(Boss)
Peel the RL-1045 Flexible Board.
ST Lens Cover (63680)
Notes on remove the ST Lens Cover (63680)
Slide and remove the ST Lens Cover (63680).
Disassembly Places
[2] #280 X 1, #331 X 1
#280
#331
Back View
DSC-WX500
4-14
4-2-5.
Upper Cabinet Section
• Refer to
“5-2-5. Upper Cabinet Section”
on exploded view for Ref. No.
(Claws)
229
228
228
227
230
226
224
225
ns
222
221
#239
(Note 1)
(Note 1)
#239
(Note 1)
(Note 1)
[1]
[2]
[3]
231
Install
North pole
Refer to “Check the
Flash Detection” for
install direction.
Flash Detection” for
install direction.
Note 1
This screw can not be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
once in servicing. Instead, use a new screw.
このねじは再利用することができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。
Disassembly Places
[1] Pop-up the flash → #239 X 1
#239
Left View
DSC-WX500
4-15
[2] #239 X 2
#239
Back View
Notes on Assembling the Upper Cabinet Section
Check the Flash Detection
This unit detects flash pop-up or down with the magnet installed in the ST Block Assy. If this magnet (for flash pop-up/
down detection) is incorrectly installed, flash pop-up/down cannot be detected.
After this magnet (for flash pop-up/down detection) is replaced or removed, carry out the following steps to check
operation.
down detection) is incorrectly installed, flash pop-up/down cannot be detected.
After this magnet (for flash pop-up/down detection) is replaced or removed, carry out the following steps to check
operation.
Magnet
(for flash pop-up/down detection)
(for flash pop-up/down detection)
1.
Turn on the unit. (press the flash down)
2.
Set the flash mode to “ Fill-flash”, and check that the “ ” is not appeared on the display.
If “ ” is appeared, the magnet may be installed in an incorrect orientation. Remove the magnet and reinstall it in the
correct orientation, and then recheck operation.
correct orientation, and then recheck operation.
Turn the magnet upside down
DSC-WX500
4-16
Click on the first or last page to see other DSC-WX500 service manuals if exist.