Sony DSC-W330 (serv.man2) Service Manual ▷ View online
DSC-W330_L2
2-2
The charging capacitor (C901) of the MA-465 flexible board is
charged up to the maximum 315 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
charged up to the maximum 315 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of
a resistor of 1 k
a resistor of 1 k
Ω /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.
prevent electrical shock.
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked
of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is
possible that a wire is snapped.
• When installing a connector, don’t press down at wire of con-
nector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
DISCHARGING OF THE CHARGING CAPACITOR (C901)
Note: High-voltage cautions
Discharging the Capacitor
Short-circuit between two points
with the short jig about 10 seconds.
Short-circuit between two points
with the short jig about 10 seconds.
R:1 k
Ω/1W
(Part code:1-215-869-11)
C901
MA-465 Flexible
Board
Board
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Wrap insulating tape.
DSC-W330_L2
2-3
2-1. EXPLODED VIEWS
2-1-1. REAR SECTION
Ref. No.
Part No.
Description
Ref. No.
Part No.
Description
* 1
4-171-156-01 FRAME (620), MAIN
* 2
4-171-169-01
INSULATING SHEET (620), SY
3
4-168-192-01
SHEET (680), LCD INSULATING
4
4-171-154-01
CUSHION (620), LCD (Note 2)
5
4-171-152-01
WINDOW (620), LCD (Note 2)
6
1-880-210-11
FPC-020 FLEXIBLE BOARD
7
A-1731-540-A SW-563 BOARD, COMPLETE
8
X-2546-065-1 CABINET (REAR) ASSY (620C) (SILVER) (Note 3)
8
X-2546-066-1 CABINET (REAR) ASSY (620D) (BLACK) (Note 3)
8
X-2546-067-1 CABINET (REAR) ASSY (620E) (RED) (Note 3)
8
X-2546-068-1 CABINET (REAR) ASSY (620F) (BLUE) (Note 3)
LCD901 1-802-983-11
LCD MODULE (LMS300GF07)
#65
2-635-591-01
SCREW (M1.4), NEW TRUSTAR P2 (Note 1)
#147
2-662-396-41
SCREW (M1.4), NEW, TRUSTAR, P2 (Note 1)
Front/Top Section
(See page 2-4)
(See page 2-4)
#65
#147
(Note 1)
#147
(Note 1)
#65
#147
(Note 1)
#147
(Note 1)
#65
#147
(Note 1)
#147
(Note 1)
#65
#147
(Note 1)
#147
(Note 1)
3
LCD901
1
8
(Note 3)
4
1
2
7
2
6
4
(Note 2)
5
(Note 2)
3
1
(Claw)
2
(Claw)
5
1. Remove to numerical order (
1
to
5
) in the left figure.
DISASSEMBLY
1
#65 / #147 X 7
Screw
#65: M1.4 X 3.5
(Silver)
2-635-591-01
2-635-591-01
3.5
1.4
3.5
1.4
#147: M1.4 X 3.5
(Black)
2-662-396-41
2-662-396-41
Note
Note 1
THE COMBINATION OF CABINET’S
COLOR AND SCREW
COLOR AND SCREW
Screw's
Ref. No. (Parts Color.)
Ref. No. (Parts Color.)
#65 (Silver)
SILVER/RED
#147 (Black)
BLACK/BLUE
Cabinet's Color
Table 2-1
The screw pointed is different according to the cabinet's color.
For the combination of cabinet's color and screw, please refer to Table 2-1.
For the combination of cabinet's color and screw, please refer to Table 2-1.
4
#65 / #147 X 1
5
#65
#147
#147
Bottom View
Left View
Right View
#65
#147
#147
#65
#147
#147
#65
#147
#147
Bottom View
DISCHARGING OF THE CHARGING CAPACITOR
Note 2: Refer to “Assembly-5:Attaching Method of LCD Cushion
(620),LCD Window (620)”
Note 3: Refer to “Assembly-4:Precaution During of Cabinet
(Rear) Assy Instalation”.
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.0 are shown in blue.
Ver. 1.1 2010.01
DSC-W330_L2
2-4
2-1-2. FRONT/TOP SECTION
Ref. No.
Part No.
Description
Ref. No.
Part No.
Description
51
X-2546-049-1 CABINET (FRONT) ASSY (620C) (SILVER)
51
X-2546-050-1 CABINET (FRONT) ASSY (620D) (BLACK)
51
X-2546-051-1 CABINET (FRONT) ASSY (620E) (RED)
51
X-2546-052-1 CABINET (FRONT) ASSY (620F) (BLUE)
52
4-171-162-01
CABINET (R (620)), SIDE
53
4-171-151-01
LIGHT (610), TALLY GUIDE,
54
1-880-206-11
FPC-016 FLEXIBLE BOARD
* 55
4-172-859-01
SHEET (610), ST
56
A-1731-543-A ST-226 BOARD, COMPLETE
* 57
4-171-166-01
INSULATING SHEET (610), ST
58
X-2546-070-1 CABINET (UPPER) ASSY (620)
59
1-880-589-11
MA-465 FLEXIBLE BOARD (Note 2)
60
4-171-158-01
RETAINER (620), CAPACITOR
BT900
1-756-710-12
LITHIUM RECHARGEABLE BATTERY
C901
1-116-439-21
CAP, ELECT 56uF 315V
MIC901 1-542-757-31 MICROPHONE
UNIT
SP901 1-858-297-11 LOUDSPEAKER
(1.0CM)
#65
2-635-591-01
SCREW (M1.4), NEW TRUSTAR P2 (Note 1)
#147
2-662-396-41
SCREW (M1.4), NEW, TRUSTAR, P2 (Note 1)
MIC901
C901
#65
55
9-1
55
9-2
: BT900 (LITHIUM RECHARGEABLE BATTERY)
Board on the mount position.
(See page 6-6)
Board on the mount position.
(See page 6-6)
6
51
qa
59
(Note 2)
q;
60
8
58
7
52
Main Section
(See page 2-5)
(See page 2-5)
9
56
54
53
57
SP901
BT900
8
(Claw)
#65
#147
(Note 1)
#147
(Note 1)
1. Remove to numerical order (
6
to
qa
) in the left figure.
DISASSEMBLY
6
#65 / #147 X 1
Screw
#65: M1.4 X 3.5
(Silver)
2-635-591-01
2-635-591-01
3.5
1.4
#65
#147
Bottom View
3.5
1.4
#147: M1.4 X 3.5
(Black)
2-662-396-41
2-662-396-41
Note
Note 2: Refer to “Assembly-3: Precaution During of MA-465
Flexible Board Instalation”.
Note 1
THE COMBINATION OF CABINET’S
COLOR AND SCREW
COLOR AND SCREW
Screw's
Ref. No. (Parts Color.)
Ref. No. (Parts Color.)
#65 (Silver)
SILVER/RED
#147 (Black)
BLACK/BLUE
Cabinet's Color
Table 2-1
The screw pointed is different according to the cabinet's color.
For the combination of cabinet's color and screw, please refer to Table 2-1.
For the combination of cabinet's color and screw, please refer to Table 2-1.
9
ST SHEET (610) (
9-1
)
→ ST SHEET (610) (
9-2
)
8
#65 X 1
#65
Back View
Caution
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Dispose of used batteries according to the instructions.
Replace only with the same or equivalent type.
Dispose of used batteries according to the instructions.
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.0 are shown in blue.
Ver. 1.1 2010.01
DSC-W330_L2
2-5
Ref. No.
Part No.
Description
Ref. No.
Part No.
Description
101
4-171-164-01
LID (620), MC (SILVER)
101
4-171-164-11
LID (620), MC (BLACK)
101
4-171-164-21
LID (620), MC (RED)
101
4-171-164-31
LID (620), MC (BLUE)
102
4-171-165-01
HINGE (620), MC LID
103
4-171-160-01
CABINET (L (620)), SIDE (SILVER)
103
4-171-160-11
CABINET (L (620)), SIDE (BLACK)
103
4-171-160-21
CABINET (L (620)), SIDE (RED)
103
4-171-160-31
CABINET (L (620)), SIDE (BLUE)
104
X-2546-057-1 CABINET ASSY (620C), CENTER (SILVER)
104
X-2546-058-1 CABINET ASSY (620D), CENTER (BLACK)
104
X-2546-059-1 CABINET ASSY (620E), CENTER (RED)
104
X-2546-060-1 CABINET ASSY (620F), CENTER (BLUE)
* 105
3-289-764-01 GASKET (280)
106
4-168-198-01
INSULATING SHEET (670) (Note 1)
107
A-1760-852-A SY-243 BOARD, COMPLETE (SERVICE)
*BT901 1-780-835-11
TERMINAL BOARD BATTERY (Note 2)
*BT902 1-780-835-11
TERMINAL BOARD BATTERY (Note 2)
*BT903 1-780-835-11
TERMINAL BOARD BATTERY (Note 2)
2-1-3. MAIN SECTION
SY
-243
qs
Lens Block
Section
(See page 2-6)
qd
107
106
(Note 1)
-13
BT901
(Note 2)
(Note 2)
BT902
(Note 2)
(Note 2)
BT903
(Note 2)
(Note 2)
105
103
101
102
qf
104
105
1. Remove to numerical order (
qs
to
qf
) in the left figure.
2. The meaning of the sign in left figure is as follows. Be careful when it removes.
◇-X
: Solder
DISASSEMBLY
Note
Note 1: Refer to “Assembly-2:Insulating Sheet (670) Puting Posi-
tion”.
Note 2: Refer to “Assembly-1:Installation Method of Battery
Terminal Board”.
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.0 are shown in blue.
Ver. 1.1 2010.01
Click on the first or last page to see other DSC-W330 (serv.man2) service manuals if exist.