Sony DSC-RX100M4 (serv.man2) Service Manual ▷ View online
2-7.
Cleaning of the EVF
This unit makes it possible to disassemble the EVF from the finished state to clean it. When a problem related to dust
is indicated from a customer, remove the VF eyepiece block in the following procedure and clean it.
When cleaning the VF eyepiece block, use birdlime or the like to remove dust.
is indicated from a customer, remove the VF eyepiece block in the following procedure and clean it.
When cleaning the VF eyepiece block, use birdlime or the like to remove dust.
• Recommended jig: J-6082-726-A Cleaning Stick II
Note
• Carry out the cleaning work in a clean environment to avoid dust or foreign matter during disassembling.
Use a clean booth if possible.
• Do not use an air blower because it raises surrounding dust.
• Do not use cleaning cloth that causes wiping unevenness.
• Do not use cleaning cloth that causes wiping unevenness.
2-7-1.
Removing the VF Eyepiece Block
Preparation:
Make a jig as shown below by bending fine wire.
Approx. 30 mm
Approx. 5 mm
Approx. 0.7 mm
Approx. 30 mm
Procedure:
1.
Depress the viewfinder pop-up switch to pop up the EVF.
2.
Draw the VF eyepiece block.
Viewfinder
pop-up switch
pop-up switch
Holes
DSC-RX100M4
2-9
3.
Insert both ends of the jig into the holes of the VF eyepiece block, gently hold the jig, and then pull out the
VF eyepiece block while pushing the internal bosses.
VF eyepiece block while pushing the internal bosses.
Note
Do not scratch the main body with the jig.
VF eyepiece block
Be careful not to touch
the grease applied to
below parts.
the grease applied to
below parts.
Note :
Grease
DSC-RX100M4
2-10
Section 3
Adjustment
For adjusting these models, the Adjust Station and the Adjust Manual are required.
Adjust Station
It is the software to start up Adjust Manual for each model.
The installer of the Adjust Station and the installation manual are attached, be sure to confirm the contents of them.
The installer of the Adjust Station and the installation manual are attached, be sure to confirm the contents of them.
Adjust Manual
It is the software to adjust and check digital cameras and camcorders for service.
The installer of the Adjust Manual and the installation manual are attached, be sure to confirm the contents of them.
The installer of the Adjust Manual and the installation manual are attached, be sure to confirm the contents of them.
Note
Be sure to install Adjust Station first.
DSC-RX100M4
3-1
Click on the first or last page to see other DSC-RX100M4 (serv.man2) service manuals if exist.