DOWNLOAD Sony WX-800UI Service Manual ↓ Size: 7.44 MB | Pages: 52 in PDF or view online for FREE

When mounting in a Japanese car, see “Mounting 
the unit in a Japanese car”.

You can use a commercially available double DIN 
installation kit. Choose an installation kit with the 
following panel frame size.
Larger than 172 × 97 mm (6 

7

/

8

 × 3 

7

/

8

 in) (w/h), with 

an inner corner radius of less than 0.5 mm (

1

/

32

 in).

Note
Be sure to use the supplied screws 

.

You may not be able to install this unit in some 
makes of Japanese cars. In such a case, consult your 
Sony dealer.

When mounting this unit to the preinstalled 
brackets of your car, use the supplied screws 

 in 

the appropriate screw holes, based on your car: T 
for TOYOTA, M for MITSUBISHI and N for NISSAN.

Note
To prevent malfunction, install only with the supplied 
screws .

When replacing the fuse, be sure 
to use one matching the 
amperage rating stated on the 
original fuse. If the fuse blows, 
check the power connection and 
replace the fuse. If the fuse blows 
again after replacement, there 
may be an internal malfunction. In such a case, 
consult your nearest Sony dealer.

•  This set can be disassembled in the order shown below.

Note: Follow the disassembly procedure in the numerical order given.

3 two bosses

4 three claws

3 two bosses

5 cover

1 mini fuse (blade type) (10A/32V)

2 Insert the screwdriver into 

Note: When installing the cover, check 

that four bosses are all locked.

1 two claws

1 two claws

1 two claws

4 panel front block

2 Remove the panel front block

3 connector

Note: When installing the cable flexible flat (22 core) (FFC2) to the connector (CN101) on the MAIN board, 
 

insert straight to the connector and lock a connector completely. No slanting after insertion.

1 screw

u 6)

1 screw

u 6)

6 two screws

u 4)

7 bracket (CD)

8 CD mechanism deck

1 two screws

u 6)

2 Lift up the CD mechanism block 

Note 2: When installing the CD mechanism 
 

block, align the rib and the slot.

Note 2: When installing the CD mechanism 
 

block, align the rib and the slot.

5 cable flexible flat 

Note 3: When installing the cable flexible flat (27 core) (FFC1), insert straight to the connector and lock a connector completely.
 

No slanting after insertion.

3 Unlock the connector.

4 Unlock the connector.

1 cable flexible flat (27 core) 

5

3 cable flexible flat (27 core) 

4 Lock

2 Lock

Note 1: The service manual of the mechanism deck, used 

in this model has been issued in a separate volume. 
Please refer to the service manual of the MG-101 
series for the mechanism deck information.