Sony PCM-D100 Service Manual ▷ View online
PCM-D100
17
2-19. MIC SW ASSY
1 two washerhead screws
(P
M1.4
u 3.5)
2 Remove the MIC SW assy
in the direction of an arrow.
3 MIC SW assy
Note
1: When installing the MIC SW
assy, insert two switch levers
to the slot of MIC assy.
switch lever
switch lever
slot
slot
MIC wire (L-ch)
screw hole
screw hole
MIC wire (R-ch)
0,&ZLUHVHWWLQJ
Note 2: When installing the MIC SW assy, check that the MIC
wire is arranged as shown in the following figure.
–)URQWERWWRPYLHZ–
PCM-D100
18
2-20. MIC ASSY (MIC1)
1 stopper
(M1.7
u 3.0)
1 stopper
(M1.7
u 3.0)
ditch
2 MIC (L) assy
2 MIC (R) assy
– Front top view –
– MIC (L) assy rear view –
– MIC (R) assy rear view –
Note 2: Check the “L” mark not
to mistake right and left.
Note 2: Check the “R” mark not
to mistake right and left.
Note 3: Align the screw hole.
ditch
ditch
ditch
Note 3: Align the screw hole.
MetKoG oI instaOOinJ tKe MIC assy (MIC)
Note 1: When replacing the MIC assy (MIC1),
replace left and right at the same time.
Do not replace only one side.
PCM-D100
19
2-21. KNOB ASSY
1 two stoppers
(M1.7
u 3.0)
2 Remove the knob assy in
the direction of an arrow.
3 knob assy
– Front bottom view –
2-22. PANEL (REAR) BLOCK
1 four foots (rear)
– Rear bottom view –
2 four shafts (lid lock)
3 panel (rear) block
PCM-D100
20
2-23. BATTERY CASE LID BLOCK
1 hook
1
2
2 hook
3 spring (lid lock)
4 shaft (lid lock)
4 shaft (lid lock)
5 slider (BATT lid)
– Rear bottom view –
6 two screws
(M1.4)
7 battery case lid block
Note: When installing the spring (lid lock),
install two hooks to numerical order.
0etKoG oI iQVtaOOiQJ tKe VSriQJ OiG OoFN
2-24. SLOT LID BLOCK
1 two stoppers
(M1.7
u 3.0)
hole
hole
hole
boss
boss
boss
2 slot lid block
Note: When installing the slot lid block,
align four holes and four bosses.
– Rear bottom view –
Click on the first or last page to see other PCM-D100 service manuals if exist.