Sony DHC-FL5D / HCD-FL5D Service Manual ▷ View online
21
HCD-FL5D
2
screw (BVTP3
×
8)
1
two screws
(BVTP3
(BVTP3
×
8)
4
two connectors
(CN803, 804)
(CN803, 804)
6
two connectors
(CN801)
(CN801)
7
SP relay board
5
two claws
front rear AMP board
center SW AMP board
3
chassis
3-22. SP RELAY BOARD
HCD-FL5D
22
• This set can be assembled in the order shown below.
4-1.
ASSEMBLY FLOW
SECTION 4
ASSEMBLY
4-4. STOCKER SECTION INSTALLATION
(Page 23)
4-3. SLIDER (SELECTION) INSTALLATION
(Page 23)
4-2. GEARS INSTALLATION
(Page 22)
4-5. CHASSIS (MOLD B) SECTION
INSTALLATION (Page 24)
1
Slide the slider (u/d)
fully in the arrow
direction.
fully in the arrow
direction.
3
gear (gear B)
2
gear (U/D slider)
4
gear (gear A)
portion A
Adjust the gear (gear B) with the
portion A as shown.
portion A as shown.
slider (U/D) gear
Adjust the gear so that it meshes with
the bottom tooth of slider (U/D) gear,
as shown.
the bottom tooth of slider (U/D) gear,
as shown.
gear
(gear B)
(gear B)
linearly
Adjust so as to be aligned with
gear B linearly, as shown.
gear B linearly, as shown.
4-2.
GEARS INSTALLATION
Note:
Follow the assembly procedure in the numerical order given.
HCD-FL5D
23
2
portion A of tray (sub)
1
stocker section
3
two step screws
3
two step screws
Hook the portion A of tray (sub)
to the slider (selection).
to the slider (selection).
portion A
of tray (sub)
of tray (sub)
sticking of
slider (selection)
slider (selection)
2
gear (chuking)
6
two screws
(PTPWH M2.6)
(PTPWH M2.6)
5
washer
3
convex portion of
slider (selection)
slider (selection)
4
compression spring
7
Insert the slider (selection)
into the portion A.
1
rotary encoder
rotary encoder
Align with the slot of
rotary encoder.
rotary encoder.
align marking
portion A
Gear (chuking)
Insert a convex portion into
a groove of gear (chuking).
a groove of gear (chuking).
4-3.
SLIDER (SELECTION) INSTALLATION
4-4.
STOCKER SECTION INSTALLATION
HCD-FL5D
24
3
three screws
(BVTP M2.6)
(BVTP M2.6)
2
Insert the gear (eject)
under the gear (LD
deceleration).
under the gear (LD
deceleration).
1
Insert the portion A of
chassis (mold B) section
into the portion B of
slider (selection).
chassis (mold B) section
into the portion B of
slider (selection).
gear (LD deceleration)
portion A
portion B of
slider (selection)
slider (selection)
4-5.
CHASSIS (MOLD B) SECTION INSTALLATION
Click on the first or last page to see other DHC-FL5D / HCD-FL5D service manuals if exist.