Sharp LC-37D65 (serv.man10) User Manual / Operation Manual ▷ View online
Introduction
2
1
3
16
7 8
9
10
4
5
6
13
12
11
14
15
EXT4 (ANALOGUE RGB/AUDIO)
terminals*
HDMI1 (HDMI) terminal
HDMI2 (HDMI/AUDIO) terminals*
EXT3 (COMPONENT/AUDIO)
terminals
OUTPUT (AUDIO) terminals
DIGITAL AUDIO OUTPUT terminal
1
2
3
4
3
4
5
6
6
TV (Front view)
TV (Rear view)
Antenna terminal
RS-232C terminal
EXT1 (RGB) terminal
EXT2 (RGB) terminal
COMMON INTERFACE slot
EXT8 terminals
HDMI3 (HDMI) terminal
USB terminal
Headphones
AC INPUT terminal
7
8
9
10
11
12
13
14
15
16
8
9
10
11
12
13
14
15
16
WARNING:
Excessive sound pressure from earphones and headphones can cause hearing loss.
4
OPC sensor
Remote control sensor
OPC indicator
B (Standby/On) indicator
MENU
button
a (Power) button
i
k/l Volume
buttons
P
r/s
Programme (channel)
buttons
buttons
b (INPUT SOURCE)
button
button
The HDMI2 and EXT4 terminals
can both use the same audio input
terminal. However, the proper item
must be selected in the “PC Audio
Select” menu (Refer to page 36 for
details).
can both use the same audio input
terminal. However, the proper item
must be selected in the “PC Audio
Select” menu (Refer to page 36 for
details).
*
LC-3237D65E_GB.indd 4
LC-3237D65E_GB.indd 4
2008/07/08 18:52:01
2008/07/08 18:52:01
Confirm that there are eight screws with the
stand unit.
Attach the supporting post for the stand unit
onto the base using the four screws with the
screw driver (supplied) as shown.
1
2
Preparation
Inserting the stand.
Insert the stand into the openings on the
bottom of the TV (Hold the stand so it will
not drop from the edge of the base area).
Insert and tighten the four screws into the
Insert and tighten the four screws into the
four holes on the rear of the TV.
3
1
2
NOTE
To detach the stand unit, perform the steps in reverse
order.
order.
•
Supplied accessories
Attaching the stand unit
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
•
•
•
•
•
•
5
Remote control unit
(
g1)
AC cord (
g1)
Stand unit (
g1)
Cable clamp (
g1)
Pages 3 and 6
Page 5
Page 8
Page 8
Operation manual (This publication)
•
“AAA” size alkaline battery (
g2) ... Page 6
•
Product shape varies in some countries.
Supporting
post
post
Soft cushion
LC-3237D65E_GB.indd 5
LC-3237D65E_GB.indd 5
2008/07/08 18:52:03
2008/07/08 18:52:03
Preparation
Inserting the batteries
Before using the TV for the first time, insert two supplied “AAA” size alkaline batteries. When the batteries become
depleted and the remote control unit fails to operate, replace the batteries with new “AAA” size batteries.
depleted and the remote control unit fails to operate, replace the batteries with new “AAA” size batteries.
Open the battery cover.
Insert two supplied “AAA” size alkaline batteries.
Insert two supplied “AAA” size alkaline batteries.
Place batteries with their terminals corresponding to the
(
(
e) and (f) indications in the battery compartment.
Close the battery cover.
CAUTION
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.
Do not mix batteries of different types. Different types of batteries have different characteristics.
Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you
find any chemical leakage, wipe thoroughly with a cloth.
The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
If you will not be using the remote control unit for an extended period of time, remove the batteries from it.
When replacing the batteries, use alkaline batteries instead of zinc-carbon ones.
Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you
find any chemical leakage, wipe thoroughly with a cloth.
The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
If you will not be using the remote control unit for an extended period of time, remove the batteries from it.
When replacing the batteries, use alkaline batteries instead of zinc-carbon ones.
Note on disposing batteries:
The batteries provided contain no harmful materials such as cadmium, lead or mercury.
Regulations concerning used batteries stipulate that batteries may no longer be thrown out with the household
rubbish. Deposit any used batteries free of charge into the designated collection containers set up at commercial
businesses.
The batteries provided contain no harmful materials such as cadmium, lead or mercury.
Regulations concerning used batteries stipulate that batteries may no longer be thrown out with the household
rubbish. Deposit any used batteries free of charge into the designated collection containers set up at commercial
businesses.
Using the remote control unit
Use the remote control unit by pointing it towards the remote control sensor. Objects between the remote control
unit and sensor may prevent proper operation.
unit and sensor may prevent proper operation.
1
2
2
•
3
•
•
•
•
•
•
•
•
•
Cautions regarding the remote control unit
Do not expose the remote control unit to shock. In addition, do not expose the
remote control unit to liquids, and do not place in an area with high humidity.
Do not install or place the remote control unit under direct sunlight. The heat
may cause deformation of the unit.
The remote control unit may not work properly if the remote control sensor of
the TV is under direct sunlight or strong lighting. In such cases, change the
angle of the lighting or the TV, or operate the remote control unit closer to the
remote control sensor.
remote control unit to liquids, and do not place in an area with high humidity.
Do not install or place the remote control unit under direct sunlight. The heat
may cause deformation of the unit.
The remote control unit may not work properly if the remote control sensor of
the TV is under direct sunlight or strong lighting. In such cases, change the
angle of the lighting or the TV, or operate the remote control unit closer to the
remote control sensor.
•
•
•
30°
30°
6
5 m
Remote control sensor
LC-3237D65E_GB.indd 6
LC-3237D65E_GB.indd 6
2008/07/08 18:52:06
2008/07/08 18:52:06
Quick guide
1
2
3
Initial installation overview
Follow the steps below one by one when using the TV for the first time. Some steps may not be necessary
depending on your TV installation and connection.
depending on your TV installation and connection.
Connect an antenna cable to
the antenna terminal (Page 8).
If necessary, insert a CA card
into the CI slot to watch
scrambled broadcasts (Pages
8 and 19).
Connect the AC cord to the TV
(Page 8).
Product shape varies in some countries.
n
o
p
Turn on the power using a on
the TV (Page 10).
Run the initial auto installation
(Page 9).
Language setting
English
Italiano
Svenska
Home/Store setting
STORE
HOME
Country setting
Austria A B/G
Finland FIN B/G
Greece GR B/G
Channel search setting
Analogue Search
Digital Search
n
o
✔
✔
✔
✔
Congratulations!
Now you can watch TV.
If necessary, adjust the
Now you can watch TV.
If necessary, adjust the
antenna to attain maximum
signal reception (Page 9).
n
o
o
7
Preparation
Power on and
run the auto
installation
Watch TV
Connect
external devices
Connect external
devices such as a
DVD player/recorder
as instructed (Pages
15–17).
Connect external
audio devices such as
speakers/amplifier as
instructed (Pages 15
and 18).
n
o
Start searching
channels
LC-3237D65E_GB.indd 7
LC-3237D65E_GB.indd 7
2008/07/08 18:52:08
2008/07/08 18:52:08
Click on the first or last page to see other LC-37D65 (serv.man10) service manuals if exist.