DOWNLOAD Sharp XV-Z90E Service Manual ↓ Size: 758.22 KB | Pages: 45 in PDF or view online for FREE

13

• 

Press the lamp unit firmly into the lamp unit compartment.
Fasten the securing screws.

 

• 

If the lamp unit lamp unit cover are not correctly installed, the power will not turn on, even
if the power cord is connected to the projector.

14

• 

Plug the power cord into the AC socket of the projector.

• 

In the following order, press “ON”, “INPUT”,
“UNDO”, ADJ LEFT”, “ENTER” and “ADJ RIGHT”.
Then press the “ON” key.

• 

“LAMP 0000H” is displayed, indicating that the
lamp timer is reset.

• 

Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer and
continue to use the same lamp, this may cause
the lamp to become damaged or explode.

 

• 

You need to reset the lamp timer every time you
replace the lamp and confirm it is reset on the
“Lamp Timer” menu.

15

• 

Be sure to unplug the power cord before cleaning the projector.

• 

The cabinet as well as the operation panel is made of plastic. Avoid using benzene or
thinner, as these can damage the finish on the cabinet.

• 

Do not use volatile agents such as insecticides on the projector.
Do not attach rubber or plastic items on the projector for long time.
The effects of some of the agents in the plastic may cause damage to the quality or finish
of the projector.

 

• 

Wipe off dirt gently with a soft flannel cloth.

 

• 

When the dirt is hard to remove, soak a cloth in a neutral detergent diluted with water,
wring the cloth well and then wipe the projector.
Strong cleaning detergents may discolour, warp or damage the coating on the projector.
Make sure to test on a small, inconspicuous area on the projector before using.

• 

Use a commercially available blower or lens cleaning paper (for glasses and camera
lenses) for cleaning the lens. Do not use any liquid type-cleaning agents, as they may
wear off the coating film on the surface of the lens.

 

• 

As the surface of the lens can easily get damaged, be sure not to scrape or hit the lens.

• 

Use a vacuum cleaner to clean dust from the exhaust
vent and the intake vent. 

16

AN-60KT

Ceiling Mount Bracket

AN-TK201

High Ceiling Installation

AN-TK202

Standard Ceiling Installation

Note

• 

The projector lens should be centred in the middle of the screen. If the horizontal line
passing through the lens centre is not perpendicular to the screen, the image will be
distorted, making viewing difficult.

• 

For optimal image, position the screen so that it is not in direct sunlight or room light.
Light falling directly on the screen washes out the colours, making viewing difficult. Close
the curtains and dim the lights when setting up the screen in a sunny or bright room.

• 

A polarising screen cannot be used with this projector.