Sharp MX-M182 / MX-M182D (serv.man25) Service Manual / Technical Bulletin ▷ View online
Sharp Electronics (UK) Ltd., Document Systems Support
5/5
(3) Connect the harness.
(4) Cut out the part as shown in the following figure and close the rear cabinet.
Then, take out the harness from the cutout part
(5) Validate the Coin Vendor with use of the function settings.
Change the setting of SIM26-3 to “1” to activate the coin vendor.
When the bypass tray needs to be used, change the setting of SIM26-31 to “1”
to use the bypass tray.
Connect to Coin Vendor/Auditor
(outside the machine)
Connect to Coin Vendor/Auditor
(outside the machine)
(outside the machine)
CV_AUD Harness to CN137.
Bundle the harnesses with the band.
Sharp Electronics (UK) Ltd., Document Systems Support
5/5
(3) Connect the harness.
(4) Cut out the part as shown in the following figure and close the rear cabinet.
Then, take out the harness from the cutout part
(5) Validate the Coin Vendor with use of the function settings.
Change the setting of SIM26-3 to “1” to activate the coin vendor.
When the bypass tray needs to be used, change the setting of SIM26-31 to “1”
to use the bypass tray.
Connect to Coin Vendor/Auditor
(outside the machine)
Connect to Coin Vendor/Auditor
(outside the machine)
(outside the machine)
CV_AUD Harness to CN137.
Bundle the harnesses with the band.
Sharp Electronics (UK) Ltd., Document Systems Support
5/5
(3) Connect the harness.
(4) Cut out the part as shown in the following figure and close the rear cabinet.
Then, take out the harness from the cutout part
(5) Validate the Coin Vendor with use of the function settings.
Change the setting of SIM26-3 to “1” to activate the coin vendor.
When the bypass tray needs to be used, change the setting of SIM26-31 to “1”
to use the bypass tray.
Connect to Coin Vendor/Auditor
(outside the machine)
Connect to Coin Vendor/Auditor
(outside the machine)
(outside the machine)
CV_AUD Harness to CN137.
Bundle the harnesses with the band.
Sharp Electronics (UK) Ltd., Document Systems Support
5/5
(3) Connect the harness.
(4) Cut out the part as shown in the following figure and close the rear cabinet.
Then, take out the harness from the cutout part
(5) Validate the Coin Vendor with use of the function settings.
Change the setting of SIM26-3 to “1” to activate the coin vendor.
When the bypass tray needs to be used, change the setting of SIM26-31 to “1”
to use the bypass tray.
Connect to Coin Vendor/Auditor
(outside the machine)
Connect to Coin Vendor/Auditor
(outside the machine)
(outside the machine)
CV_AUD Harness to CN137.
Bundle the harnesses with the band.
Display