DOWNLOAD Sharp MX-FWX1 Service Manual ↓ Size: 43.31 MB | Pages: 127 in PDF or view online for FREE

MX-7040N  Dehumidifying heater kit  3 – 13

1)

Attach the paper feed unit, and fix by the screw. Connect the
connector.

2)

Attach the torque limiter unit, and fix by the screw.

3)

Attach the upper cabinet, and fix by the screw.

4)

Attach the left rear cabinet, and fix by the screw.

5)

Attach the sheet, and fix by the screw. Close the upper cover.

6)

Insert the paper feed tray.

1)

Remove the screw, and remove the connector cover.

2)

Connect the connector, and tighten the screw.

MX-7040N  Dehumidifying heater kit  3 – 14

1)

Pull out the paper feed tray.

2)

Remove the screw, and remove the left front cabinet.

3)

Open the upper cover, and remove the screw.

4)

Remove the upper cabinet.

5)

Disconnect the connector. Remove the screw, and remove the
paper feed unit.

1)

Remove the screw, and remove the cover.

1)

Attach the heater, and fix by the screw. Attach the connector to
the frame, and fix the snap band.

1)

Attach the snap band of the heater harness unit, and fix by the
screw. While holding the harness upward, attach the AC cord
fixer.

NOTE: After attaching the snap band, cut and trim the end of

the band.

NOTE: Be careful not to mistake the attaching direction of the

AC cord fixer.

MX-7040N  Dehumidifying heater kit  3 – 15

2)

Pull the harness tightly in the arrow direction, and check to
confirm that there is no disconnection of the snap band and
that the square hole in the frame is not covered with the har-
ness.

3)

Connect the connector of the heater harness unit. Attach the
earth wire, and fix by the screw.

NOTE: Attach the earth wire at an angle of 45 degrees.

1)

Attach the heater cover with the screws (M4 x 8).

2)

Attach the  heater sheet.

For the reference, see below.

NOTE: Attach the sheet so that it does not extend out from the

X and Y lines.

45q

Top view

X

Y

MX-7040N  Dehumidifying heater kit  3 – 16

1)

Attach the cover, and fix the screw.

1)

Attach the paper feed unit, and fix by the screw. Connect the
connector.

2)

Attach the upper cabinet.

3)

Fix the screw, and close the upper cover.

4)

Attach the left front cabinet, and fix by the screw.

5)

Insert the paper feed tray.

1)

Remove the screw, and remove the connector cover.

2)

Connect the connector, and tighten the screw.