DOWNLOAD Sharp MX-2630 Service Manual ↓ Size: 66.16 MB | Pages: 127 in PDF or view online for FREE

MX-2630N  Heater kit  5 – 21

1)

Clean the label attaching surface of the tray 2 by the alcohol and
affix the high temperature warning label onto the frame.

2)

Attach the paper feed tray.

1)

Attach the right rear cabinet.

2)

Attach the rear cabinet.

3)

Attach the Connector cover.

1)

Remove the rear cabinet cover of the machine.

0mm

0.5mm

0mm

0.5mm

ĭ

ĭ

Ĭ

ĭ

ĭ

ĭ

Ĭ

ĭ

Ĭ

MX-2630N  Heater kit  5 – 22

2)

Attach the edge saddle. 

3)

Connect the heater harness to the machine harness.

The heater harness are held by the Edge saddle.

4)

Cut the part of the removed cover shown in the figure.

5)

Attach the rear cabinet cover of the machine.

1)

Remove screws and remove Rear cabinet.

2)

Remove screws and remove Left front cabinet and Left rear cabi-
net.

3)

Remove screws and remove LCC unlock connecting plate.

Be careful of the mounting direction.
Open the right side.

1 stage desk: No.12
2/3 stage desk: No.14

Ĭ

ĭ

Į

Ĭ

Ĭ

Ĭ

Ĭ

Ĭ

Ĭ

Ĭ

ĭ

MX-2630N  Heater kit  5 – 23

4)

Remove the harnesses on Paper feed unit from the Edge saddle.

Remove screws, slightly pull out the rear side of the LCC connect-
ing plate left toward front and slightly slide toward rear side.
Remove the harness avoiding the section A.

1)

Attach Heater and M clamp. Put the harness through the M
clamp.

2)

Attach LCC connecting plate left and put the harnesses through
the Edge saddle on Paper feed unit.

1)

 Attach AC cord fixer and Heater harness as shown below and fix
the round terminal with a screw.
Connect the Heater harness connector and Heater connector.

Ĭ

ĭ

A

*CTPGUUGU

'FIGUCFFNG

2CRGTHGGFWPKV

Ĭ

ĭ

A

*CTPGUUGU

'FIGUCFFNG

2CRGTHGGFWPKV

MX-2630N  Heater kit  5 – 24

1)

Attach the LCC unlock connecting plate.

2)

Attach Left front cabinet and Left rear cabinet.

3)

Attach Rear cabinet.

4)

Paste a protection sheet according to the cutout position on the
plate.

1)

Remove the connector cover.

Do not use the connector cover removed.

2)

Connect the connector.

If the heater kit is not installed, there is no need to connect the
heater connector to the connector.

ĭ

ĭ

ĭ

ĭ

ĭ

ĭ

ĭ

Ĭ

Ĭ

ĭ

.%%JCTPGUUKUEQXGTGFYKVJCEQPPGEVQTEQXGT