Sharp DX-CS10 Service Manual ▷ View online
[4] Preventive maintenance
4-9
“Almost Full Waste Toner Bottle”
Waste toner bottles cannot be reused.
For easy replacement, we recommend you purchase and store extra waste toner
bottles.
bottles.
When removing the waste toner bottle, make sure not to tilt it.
Make sure the transfer unit is installed. If the transfer unit is not installed, install it before
turning on the power.
turning on the power.
Before removing the waste toner bottle from the machine, spread paper or similar
material around the area to keep toner from dirtying your workspace.
material around the area to keep toner from dirtying your workspace.
1. Pull the opening lever on the front cover, and then carefully lower the front cover.
2. Slide both levers on the front cover forward.
3. Holding the tabs on both ends of the transfer unit, tilt it backwards then lift it up.
[4] Preventive maintenance
4-10
4. Hold the center of the waste toner bottle, and then carefully pull it partially out without tilting
it.
5. Pull the waste toner bottle halfway out, grab the bottle firmly, and then pull it straight out.
To prevent the waste toner bottle touching the intermediate transfer unit (the position shown
[4] Preventive maintenance
4-11
by the arrow in the illustration below), do not lift the bottle while pulling it out.
6. Close the bottle cap.
7. Hold the center of the new waste toner bottle, and then carefully insert it halfway into the
machine body.
Leave the bottle cap open.
[4] Preventive maintenance
4-12
To prevent the waste toner bottle touching the intermediate transfer unit (the position shown
by the arrow in the illustration below), do not lift the bottle while inserting it.
by the arrow in the illustration below), do not lift the bottle while inserting it.
8. Push in the waste toner bottle until it clicks into place.
Push the middle part all the way in.
9. Place the transfer unit down on the front cover.
Click on the first or last page to see other DX-CS10 service manuals if exist.