Sharp AR-F11 (serv.man7) Service Manual ▷ View online
6-16
CHAPTER 6 MECHANICAL CONSTRUCTION
3) Remove the harness leads from the harness
stop [5] and edge saddle [6].
4) Disconnect the two connectors [7], and re-
move the saddle delivery tray assembly [8].
Figure 6-206
Figure 6-207
5.
Removing Upper Delivery Guide
Assembly
Assembly
1) Remove the grate-shaped lower guide (see
I-A-7).
2) Remove the two screws [1] and ground lead
[2], and remove the upper delivery guide
assembly [3].
assembly [3].
6.
Removing the PCB Cover
1) Remove the four screws [1], and remove the
PCB cover [2].
Figure 6-208
[7]
[5]
[6]
[8]
[1]
[3]
[2]
[1]
[1]
[2]
[1]
6-17
CHAPTER 6 MECHANICAL CONSTRUCTION
B.
SADDLE UNIT
1.
Removing the Saddle Unit
1) Remove the grate-shaped lower guide (see
I-A-7).
2) Remove the right guide assembly (see I-A-
8).
3) Remove the front lower door assembly (see
II-A-1).
4) Remove the rear lower cover (see II-A-2).
5) Remove the front inside cover (see II-A-3).
6) Remove the saddle delivery tray assembly
5) Remove the front inside cover (see II-A-3).
6) Remove the saddle delivery tray assembly
(see II-A-4).
Figure 6-209
Figure 6-210
7) Remove harness stop [3] and harness lead
[4].
8) Remove the upper delivery guide (see II-A-
5).
9) Remove the PCB cover (see II-A-6).
10) Disconnect two connectors [1] and remove
10) Disconnect two connectors [1] and remove
the two screws [2].
[1]
[2]
[3]
[4]
6-18
CHAPTER 6 MECHANICAL CONSTRUCTION
11) Remove the screw [5].
12) Remove the two screws [6], and remove the
saddle stitch unit [7] by moving it in the pick-
up direction.
up direction.
Figure 6-211
Figure 6-212
Figure 6-213
Caution:
When removing the saddle unit from the
finisher unit body, prevent the timing belt
[8] from catching on the communications
cable bracket [9].
finisher unit body, prevent the timing belt
[8] from catching on the communications
cable bracket [9].
[5]
[6]
[6]
[7]
[9]
[8]
6-19
CHAPTER 6 MECHANICAL CONSTRUCTION
2.
Removing the Paper Folding
Roller
Roller
1) Remove the front lower door assembly (see
II-A-1).
2) Remove the front inside cover (see II-A-3).
3) Remove the upper delivery guide (see II-A-
3) Remove the upper delivery guide (see II-A-
5).
4) Remove the PCB cover (see II-A-6).
5) Disconnect the two connectors [1].
5) Disconnect the two connectors [1].
6) Disconnect two connectors [2], remove the
three screws [3], and remove the paper push-
ing motor mount [4].
ing motor mount [4].
Figure 6-214
Figure 6-215
[1]
[2]
[2]
[3]
[4]
Click on the first or last page to see other AR-F11 (serv.man7) service manuals if exist.