Sharp AR-F11 (serv.man7) Service Manual ▷ View online
6-28
CHAPTER 6 MECHANICAL CONSTRUCTION
D.
Accessory
1.
Support tray
Install the support tray (accessory) to the
saddle delivery tray when the paper stacking on
the saddle delivery tray is significantly deterio-
rated, causing paper to drop, etc.
* 2 screws are needed to install the support tray.
* Refer to the pats list for the parts numbers and
the saddle delivery tray is significantly deterio-
rated, causing paper to drop, etc.
* 2 screws are needed to install the support tray.
* Refer to the pats list for the parts numbers and
so on.
1) Take off the saddle delivery tray (see II-A-
4).
2) Install the support tray [2] to the saddle de-
livery tray [1] with 2 screws.
3) Install the saddle delivery tray.
Figure 6-235
Figure 6-236
[2]
[3]
[1]
6-29
CHAPTER 6 MECHANICAL CONSTRUCTION
III. PUNCHER UNIT
(OPTION)
A.
Externals and Controls
[1]
Upper cover (3)
[2]
Upper cover 2
[3]
Front door
[4]
Right guide assembly (5)
Figures in parentheses ( ) indicate the
number of mounting screws.
number of mounting screws.
Figure 6-301
Figure 6-302
1.
Removing the Right Guide
Assembly
Assembly
1) Remove the five screws [1], and remove the
right guide assembly [2].
[1]
[2]
[4]
[3]
[2]
[1]
[1]
6-30
CHAPTER 6 MECHANICAL CONSTRUCTION
2.
Removing the Upper Cover
1) Open the front door [1], remove the three
screws [2], and slacken the inner side of the
right cover [3] to remove the upper cover
[4] from the hook [5].
right cover [3] to remove the upper cover
[4] from the hook [5].
Figure 6-303
Figure 6-304
B.
Puncher Driver System
1.
Removing the Punch Motor
1) Remove the upper cover (see III-A-2).
2) Disconnect the connector [1].
3) Remove the two screws [2], and remove the
2) Disconnect the connector [1].
3) Remove the two screws [2], and remove the
punch motor [3].
[2]
[2]
[4]
[4]
[3]
[5]
[1]
[3]
[1]
[2]
6-31
CHAPTER 6 MECHANICAL CONSTRUCTION
2.
Removing the Horizontal
Registration Motor
Registration Motor
1) Remove the right guide assembly (see III-
A-1).
2) Disconnect the connector [1].
3) Remove the two screws [2], and slide the
3) Remove the two screws [2], and slide the
horizontal registration motor [3] in the di-
rection of the arrow.
rection of the arrow.
Figure 6-305
3.
Removing the Punch Unit
Caution:
When removing the punch unit, the punch
unit section sometimes opens.
If necessary, perform work with the punch
unit section in an open state.
unit section sometimes opens.
If necessary, perform work with the punch
unit section in an open state.
1) Remove the right guide assembly (see III-
A-1).
2) Remove the upper cover (see III-A-2).
3) Remove the E-ring [1], washer [2] and
3) Remove the E-ring [1], washer [2] and
puncher spring [3].
Figure 6-306
[2]
[1]
[3]
[3]
[1]
[2]
Click on the first or last page to see other AR-F11 (serv.man7) service manuals if exist.