Sharp AR-C150 (serv.man7) User Manual / Operation Manual ▷ View online
7-9
CHAPTER
7
20-BIN STAPLE SORTER (AR-SS2)
1
Open the stapler cover.
2
Lift the release lever and pull out the staple box.
●
Lift the release lever to unlock the staple box. Then pull out the
box.
box.
3
Remove the empty staple cartridge from inside the
staple box.
staple box.
4
Insert the new staple cartridge into the box until it clicks
in place.
in place.
●
Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
●
The cartridge holds 5,000 staples.
NOTE:
Be sure not to remove the rear paper and tape before inserting
the cartridge.
Be sure not to remove the rear paper and tape before inserting
the cartridge.
Staple cartridge replacement
When the staple cartridge becomes empty, the message “
ADD
STAPLES.
” will appear. Replace the staple cartridge as follows:
OPTIONAL EQUIPMENT
20-bin staple sorter (AR-SS2)
7-10
CHAPTER
7
20-BIN STAPLE SORTER (AR-SS2)
5
Remove the rear paper and tape from the cartridge.
●
Pull them straight. If they are pulled obliquely, the tape may be
torn.
torn.
6
Insert the staple box into the stapler until it clicks in
place.
place.
7
Close the stapler cover.
8
Place a sheet of paper into the top bin. Press the manual
staple (
staple (
) key on the staple sorter when it lights up.
●
Check to see whether the sheet is stapled.
If it is not stapled, press the manual staple key again.
If it is not stapled, press the manual staple key again.
●
If the stapler does not operate properly even after
replacement, a staple may be jammed in it. See next page.
replacement, a staple may be jammed in it. See next page.
●
Staples for the staple sorter are available from your Sharp
dealer.
dealer.
OPTIONAL EQUIPMENT
20-bin staple sorter (AR-SS2)
7-11
CHAPTER
7
20-BIN STAPLE SORTER (AR-SS2)
1
Open the stapler cover.
2
Lift the release lever and pull out the staple box.
●
Lift the release lever to unlock the staple box. Then pull out the
box.
box.
3
Lower the lever at the end of the staple box and remove
the jammed staples.
the jammed staples.
4
Return the lever to its original position.
Staple jam removal
If staples become jammed in the stapler, the message “
CHECK
STAPLER POSITION OR STAPLE JAM.
” will appear. Remove the
jammed staples in the manner described below:
OPTIONAL EQUIPMENT
20-bin staple sorter (AR-SS2)
7-12
CHAPTER
7
20-BIN STAPLE SORTER (AR-SS2)
5
Insert the staple box into the stapler unit until it clicks in
place.
place.
6
Close the stapler cover.
7
Following the stapling procedure on page 7-8, staple a
copy to check that the stapler works properly.
copy to check that the stapler works properly.
●
If it does not, repeat this procedure until it does.
OPTIONAL EQUIPMENT
20-bin staple sorter (AR-SS2)
Click on the first or last page to see other AR-C150 (serv.man7) service manuals if exist.