Sharp PN-U553 (serv.man2) Service Manual ▷ View online
PN- U523/U473/U423 INSTALLATION, ADJUSTMENT, SETTING 2 - 2
1 – 2.MOUNTING PRECAUTIONS
• When installing, removing or moving the monitor, ensure that this
is carried out by at least 2 people.
• Be sure to use a wall-mount bracket designed or designated for
mounting the monitor.
• This monitor is designed to be installed on a concrete wall or
pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting
installation.
• This monitor and bracket must be installed on a wall which can
endure at least 4 times or more the weight of the monitor. Install
by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws
that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, hold the parts marked by
below. Do not hold the LCD panel. This may cause product
damage, failure, or injury.
•After mounting, please carefully ensure the monitor is secure,
PN- U523/U473/U423 INSTALLATION, ADJUSTMENT, SETTING 2 - 3
1 – 3.CONNECTING PERIPHERAL EQUIPMENT
(Caution)
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting cables. Also,
read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables connected to
the input and output terminals may cause malfunctions and the other problems.
(MEMO)
• Set the audio input terminal used for each input mode in AUDIO SELECT on the SETUP menu. The factory settings are shown below.
• The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing LLC in the United States and other countries.
• DisplayPort is a registered trademark of Video Electronics Standards Association.
PN- U523/U473/U423 INSTALLATION, ADJUSTMENT, SETTING 2 - 4
1 – 4.CONNECTING THE POWER CORD
• Use only the power cord supplied with the monitor.
1. Turn off the main power switch.
2. Plug the power cord (supplied) into the AC input terminal.
3. Plug the power cord (supplied) into the AC power outlet.
1 – 5.BINDING CABLES
The cables connected to the terminals on the rear of the
monitor can be fastened with the cable clamp.
Attach the cable clamp into the cable clamp attachment on the
rear of the monitor and fasten the cables.
PN- U523/U473/U423 INSTALLATION, ADJUSTMENT, SETTING 2 - 5
2. ADJUSTMENT
2 – 1.ADJUSTMENT ITEM LIST
Click on the first or last page to see other PN-U553 (serv.man2) service manuals if exist.