Sharp PN-K321 (serv.man3) Service Manual ▷ View online
CHAPTER 6. DISASSEMBLY AND ASSEMBLY
PN-K321/K322B DISASSEMBLY AND ASSEMBLY 6 – 14
8 ) Remove the ten nails that secure the LCD module and the front cover.
9 ) Remove the Front cover.
CHAPTER 6. DISASSEMBLY AND ASSEMBLY
PN-K321/K322B DISASSEMBLY AND ASSEMBLY 6 – 15
13. TOUCH PANEL CONTROL PWB PN-K322B ONLY
1 ) Remove the rear cover.
2 ) Remove six screws(M3 x 6 3W) and remove the VESA angle.
3 ) Remove the three places of the touch panel connector flexible, remove the one place the cable connector, remove four screws and remove the
touch control board.
CHAPTER 6. DISASSEMBLY AND ASSEMBLY
PN-K321/K322B DISASSEMBLY AND ASSEMBLY 6 – 16
14. EMI SHEET
1) The EMI Sheets are put on the following places. Therefore, when the VESA angle, the Main IF Shield and the LVDS cable are removed, the
EMI sheets need to be removed and cannot be used again.
- VESA angle : EMI sheet A and B need to be removed
- Main IF Shield : EMI sheet B and C need to be removed
- LVDS cable : EMI sheet D needs to be removed
-
- VESA angle : EMI sheet A and B need to be removed
- Main IF Shield : EMI sheet B and C need to be removed
- LVDS cable : EMI sheet D needs to be removed
-
A
B
C
D
3
: ’13.Dec
3
CHAPTER 6. DISASSEMBLY AND ASSEMBLY
PN-K321/K322B DISASSEMBLY AND ASSEMBLY 6 – 17
15. MYLAR SHEET
1 ) Mylar Sheet described below for the location.
3
: ’13.Dec
Click on the first or last page to see other PN-K321 (serv.man3) service manuals if exist.