Sharp UP-V9900 (serv.man3) Service Manual ▷ View online
2-12
Using BIOS
Introduction
Expansion
Installation Locations Connecting Peripheral Devices
Turn On and Off the System
Restoring HDD Drive to factory default configuration
Setting
Appendix A Appendix B
Troubleshooting
When the "Recover Pro" window appears, click on the <OK> button.
1
When the "License Agreement" window appears, click on the <I accept> button.
2
2-13
Using BIOS
Introduction
Expansion
Installation Locations Connecting Peripheral Devices
Turn On and Off the System
Restoring HDD Drive to factory default configuration
Setting
Appendix A Appendix B
Troubleshooting
The ‘Creating a partition’ window appears.
Set the size of the new partition using the ‘Select’ box at the bottom
and create a partition in which the backup of the system changes will
be placed.
When the size of the partition is set, click on the <OK> button.
Set the size of the new partition using the ‘Select’ box at the bottom
and create a partition in which the backup of the system changes will
be placed.
When the size of the partition is set, click on the <OK> button.
3
▶ The size of the partition for system changes backup should be at least 10 % of the total size of the hard disk. When the size of the backup data grows too large,
it is desirable for you to set the size of this partition yourself.
Note!
2-14
Using BIOS
Introduction
Expansion
Installation Locations Connecting Peripheral Devices
Turn On and Off the System
Restoring HDD Drive to factory default configuration
Setting
Appendix A Appendix B
Troubleshooting
When you click on the <Restart> button, Recover Pro re-starts the
system and runs Disk Defragment to secure consecutive hard disk
space.
4
On the right is shown a screen shot after all the required Recover Pro
partitions, along with an initial restore point, have been created.
The new restore point has been initially configured to compare the
system state with its previous state upon every boot and create when
there is a system change. Setting up Recover Pro is now complete.
partitions, along with an initial restore point, have been created.
The new restore point has been initially configured to compare the
system state with its previous state upon every boot and create when
there is a system change. Setting up Recover Pro is now complete.
5
▶ When the consecutive space available is larger than the size to be set, Recover Pro proceeds with the installation process without performing disk defragmentation.
Caution!
▶ For more detailed information on Recover Pro, see the attached ‘Recover PRO manual v2.00.pdf’ file.
Note!
2-15
Using BIOS
Introduction
Expansion
Installation Locations Connecting Peripheral Devices
Turn On and Off the System
Restoring HDD Drive to factory default configuration
Setting
Appendix A Appendix B
Troubleshooting
Turn Off the System
Before turning off the system, first save your information unsaved and close any application programs you use.
1
Click the <Start> button, and select ‘Turn Off Computer’ from the Start menu.
2
‘Turn Off Computer’ Screen appears, click ‘Turn off’ to shut down the
system. The system will be automatically turned off.
system. The system will be automatically turned off.
3
▶ When the system turned down by sudden power failure or system failure, press the power button and wait for 4 seconds.
Note!
Click on the first or last page to see other UP-V9900 (serv.man3) service manuals if exist.