DOWNLOAD Sharp HT-X1H Service Manual ↓ Size: 3.55 MB | Pages: 72 in PDF or view online for FREE

04/10/18

HT-X1H(E)7.fm

HT-X1H

TINSEA037SJZZ

!

Poor performance during DVD/CD playback (skipping or jumping)
can be caused by a dirty or contaminated laser pick up lens. If this
happens then the use of a commercially available lens cleaning
discs may restore normal operation. Contact your supplier or local
DVD software dealer to obtain lens cleaning discs. Ensure all
included instructions/documentation are carefully followed.
 

!

Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.

"

Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.

"

Do not apply oil to the inside of the each component. It may
cause malfunctions.

 

!

Discs are fairly resistant to damage, however mistracking can occur due
to an accumulation of dirt on the disc surface. Follow the guidelines
below for maximum enjoyment from your disc collection and player.

"

Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.

"

Keep your discs away from direct sunlight, heat, and excessive
moisture.

"

Always hold the discs by the edges. Fingerprints, dirt, or water on
the discs can cause noise or mistracking. If a disc is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.

When you load an unplayable disc or fail to perform operations
properly, the following messages are displayed on the TV screen.

 
 

Use only the specified optional accessory to operate this product
properly.
For speaker installation, read instructions supplied with stands.

"

Since the disc insertion slot fac-
es upward, dust may accumu-
late on it. Clean it with a cotton 
swab, etc.

The disc cannot be played with this 
system or it is loaded in an incor-
rect way.

The region number of the DVD is 
neither "2" nor "ALL".

The disc does not support the oper-
ation described in this operation 
manual.

Model: AD-AT11ST

Disc Error

Wrong Region

8

04/10/18

HT-X1H(E)7.fm

HT-X1H

TINSEA037SJZZ

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.

!

 

!

Including the stand
Width: 430 mm 
Height: 192 mm 
Depth: 100 mm
Excluding the stand
Width: 430 mm 
Height: 171 mm 
Depth: 88 mm

2.2 kg

FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz

SCART output: SCART terminal   1
Video output: RCA type   1
S-video output: S-terminal   1

Headphones: 16 - 50 ohms 
(recommended: 32 ohms)

Audio input (AUX): RCA type   2
Optical digital input: Square type   1

System control   2

PAL

DVD (region number 2 or ALL), 
DVD-R/RW (video mode), 
DVD+R/RW (video mode), 
super video CD, video CD, audio CD, 
CD-R, CD-RW

Horizontal resolution: 500 lines
S/N ratio: 70 dB

Linear PCM DVD:

4 Hz to 22 kHz (sampling rate: 48 kHz)

4 Hz to 44 kHz (sampling rate: 96 kHz)

CD: 4 Hz to 20 kHz

CD: 96 dB (1 kHz)

Linear PCM DVD: 95 dB

CD: 94 dB

0.006 % maximum

Bass reflex, full range system 
(magnetic shield)

8 cm speaker   1

100 W

50 W

4 ohms

Width: 105 mm 
Height: 205 mm 
Depth: 105 mm

0.9 kg/each

04/10/18

HT-X1H(E)7.fm

HT-X1H

TINSEA037SJZZ

!

 

!

!

Bass reflex, full range system

8 cm speaker   1

100 W

50 W

4 ohms

Width: 105 mm 
Height: 205 mm 
Depth: 105 mm

0.75 kg/each

Bass reflex, full range system 
(magnetic shield)

8 cm speaker   1

100 W

50 W

4 ohms

Width: 185 mm 
Height: 123 mm 
Depth: 115 mm

0.9 kg

AC 230 V, 50 Hz

Power on: 158 W

Power stand-by: 0.6 W

Width: 200 mm 
Height: 380 mm 
Depth: 443 mm

10.6 kg

Front speakers, centre speaker and 
surround speakers: more than 4 ohms

System control   2

Front speakers:

RMS: 100 W (50 W + 50 W) 
(10 % T.H.D., 1 kHz)

Centre speaker:

RMS: 50 W (10 % T.H.D., 1 kHz)

Surround speakers:

RMS: 100 W (50 W + 50 W) 
(10 % T.H.D., 1 kHz)

Subwoofer:

RMS: 50 W (10 % T.H.D., 100 Hz)

Bass reflex, 1 way system

16 cm woofer   1

100 W

50 W

4 ohms

8

Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replace-
ment, of this product subject to the conditions listed below:-

1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does

not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with
the product, or repair other than by a Service Facility appointed by Sharp.

2. As this product is intended for private domestic use only, the guarantee will not apply if the product

is used in the course of a business, trade or profession.

3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed

Service Facility within one year from the date this product was purchased. Proof of purchase must
be provided.

4. The guarantee does not cover carriage costs, audio tapes, compact discs or batteries.

5. In the unlikely event of this product requiring repair, please contact the supplier from whom it was

purchased. Where this is not possible, please contact the Sharp Customer Information Centre on
the telephone number given below.

6. No person has any authority to vary the terms or conditions of this guarantee.

7. This guarantee is offered as an additional benefit to your statutory rights, and does not affect these

rights in any way.

If you have any difficulty operating this product, or would like information on other Sharp products,
please telephone the Sharp Customer Information Centre on the number given below.

Sharp Customer Information Centre - Telephone 08705 274277

(or (01) 676 0648 if telephoning from Ireland)

0312

Sharp House, Thorp Road, Newton Heath, Manchester, M40 5BE

0401_A5

04/10/12

HT-X1H(E)_BA.fm

TINSEA037SJZZ

TINSEA037SJZZ
04M N HK  4