Sharp CD-C661H User Manual / Operation Manual ▷ View online
HK
<P=001>
USING EXTERNAL UNITS
CD
DIGITAL
OUT
■
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
through this unit:
1
Use a separately available RCA lead to connect the desired
external unit to the VIDEO/AUX sockets.
(red
external unit to the VIDEO/AUX sockets.
(red
→
right channel, white
→
left channel)
●
When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
sure to connect the audio output to this unit and the video
output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
22.
- 4 of the "Recording from the built-in radio" section on page
22.
Note:
●
To prevent hum interference, do not place this unit near a
television receiver.
television receiver.
■
CD digital output (optical)
The CD digital signal from this unit can be recorded by
other DAT or MiniDisc recorders.
other DAT or MiniDisc recorders.
1
Remove the CD DIGITAL OUT socket cover.
2
Use a commercially available digital cable to connect the unit
to the OPTICAL IN socket of a MiniDisc recorder or a DAT.
to the OPTICAL IN socket of a MiniDisc recorder or a DAT.
3
Put the external unit in the recording mode.
4
Play a CD on this unit.
Note:
●
Only CD signals can be output.
■
Headphones
●
Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
the volume level is reduced.
●
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The rec-
ommended impedance is 32 ohms.
and are between 16 ohms and 50 ohms impedance. The rec-
ommended impedance is 32 ohms.
●
When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
nected automatically. Adjust the VOLUME control for the
desired volume.
To the line output socket
RCA
lead
lead
Commercially available digital cable
CD-C661H(SUK) TINSE0264AWZZ
24
<P=002>
TRANSPORTING THE UNIT
Before you move this product to a new location, proceed
as follows:
as follows:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
●
Remove all CDs inserted in the unit.
4
Press the OPEN/CLOSE button to close the disc tray.
●
Make sure that "NO DISC" is displayed.
5
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power lead from the AC socket.
and then unplug the AC power lead from the AC socket.
RESETTING THE MICROCOMPUTER
Reset the microcomputer under the following conditions:
●
To erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
settings, and tuner and CD presets).
●
If the display is not correct.
●
If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Whilst pressing down the
5 / 3
button and the
2 / 4
button, hold down the ON/STAND-BY button for at least 1
second.
second.
Caution:
●
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
memory including clock and timer settings, and tuner and CD
presets.
MAINTENANCE
■
Internal care
●
Dirty heads, capstans or pinch rollers can cause poor sound
and tape jams. Clean these parts with a cotton swab moist-
ened with commercial head/pinch roller cleaner or isopropyl
alcohol.
and tape jams. Clean these parts with a cotton swab moist-
ened with commercial head/pinch roller cleaner or isopropyl
alcohol.
●
After long use, the deck’s heads and capstans may become
magnetised, causing poor sound. Demagnetise these parts
once every 30 hours of playing/recording time by using a com-
mercial tape head demagnetiser. Read the demagnetiser’s in-
structions carefully before use.
magnetised, causing poor sound. Demagnetise these parts
once every 30 hours of playing/recording time by using a com-
mercial tape head demagnetiser. Read the demagnetiser’s in-
structions carefully before use.
■
External care
●
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then wipe with a dry cloth.
soap solution, then wipe with a dry cloth.
●
Do not use chemically treated cleaning cloths or other chemi-
cals.
cals.
TAPE 1
TAPE 2
1,5
3,4
2
2
1,2
CD-C661H(SUK) TINSE0264AWZZ
25
<P=003>
SPECIFICATIONS
As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for
product improvement without prior notice. The performance specification figures indicated are nominal values of production
units. There may be some deviations from these values in individual units.
product improvement without prior notice. The performance specification figures indicated are nominal values of production
units. There may be some deviations from these values in individual units.
●
General
Power source:
AC 230 V, 50 Hz
Power consumption:
180 W
Dimensions:
Width; 270 mm (10-5/8")
Height; 330 mm (13")
Depth; 358 mm (14-1/8")
Height; 330 mm (13")
Depth; 358 mm (14-1/8")
Weight:
10.5 kg (23.1 lbs.)
●
Amplifier section
Output power:
RMS; 300 W (150 W + 150 W)
(10 % T.H.D.)
(10 % T.H.D.)
Output terminals:
Speakers; 6 ohms
Headphones; 16-50 ohms
(recommended; 32 ohms)
CD digital output (optical)
Headphones; 16-50 ohms
(recommended; 32 ohms)
CD digital output (optical)
Input terminals:
Video/Auxiliary (audio signal);
500 mV/47 kohms
500 mV/47 kohms
●
Compact disc player section
Type:
3-disc multi-play compact
disc player
disc player
Signal readout:
Non-contact, 3-beam semi-
conductor laser pickup
conductor laser pickup
D/A converter:
1-bit D/A converter
Frequency
response:
response:
20 - 20,000 Hz
Dynamic range:
90 dB (1 kHz)
●
Tuner section
Frequency range:
FM; 87.5-108 MHz
AM; 522 - 1,620 kHz
AM; 522 - 1,620 kHz
●
Cassette deck section
Frequency range:
50-14,000 Hz (Normal tape)
Signal/noise ratio:
55 dB (TAPE 1, playback)
50 dB (TAPE 2, recording/playback)
50 dB (TAPE 2, recording/playback)
Wow and flutter:
0.15 % (WRMS)
●
Speaker section
Type:
3-way type [20 cm (7-7/8") woofer, 8
cm (3-1/8") tweeter and super tweeter]
cm (3-1/8") tweeter and super tweeter]
Maximum input power: 300 W
Rated input power:
Rated input power:
150 W
Impedance:
6 ohms
Dimensions:
Width; 250 mm (9-13/16")
Height; 330 mm (13")
Depth; 335 mm (13-1/4")
Height; 330 mm (13")
Depth; 335 mm (13-1/4")
Weight:
6.1 kg (13.4 lbs.)/each
CD-C661H(SUK) TINSE0264AWZZ
26
CD-C661H(SUK) TINSE0264AWZZ
SHARP ELECTRONICS (U.K.) LTD.
Sharp House, Thorp Road, Newton Heath, Manchester, M40 5BE
SHARP CORPORATION
?????.??
TERMS OF GUARANTEE
Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replacement, of this
product subject to the conditions listed below:-
product subject to the conditions listed below:-
1.
This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does not cover faults
or damage caused by accident, misuse, fair wear and tear, neglect, tampering with the product, or repair other than
by a Service Facility appointed by Sharp.
or damage caused by accident, misuse, fair wear and tear, neglect, tampering with the product, or repair other than
by a Service Facility appointed by Sharp.
2.
As this product is intended for private domestic use only, the guarantee will not apply if the product is used in the
course of a business, trade or profession.
course of a business, trade or profession.
3.
To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed Service Facility
within one year from the date this product was purchased. Proof of purchase must be provided.
within one year from the date this product was purchased. Proof of purchase must be provided.
4.
The guarantee does not cover carriage costs, jewelled styli, audio tapes, compact discs or batteries.
5.
In the unlikely event of this product requiring repair, please contact the supplier from whom it was purchased.
Where this is not possible, please contact the Sharp Customer Information Centre on the telephone number given
below.
Where this is not possible, please contact the Sharp Customer Information Centre on the telephone number given
below.
6.
No person has any authority to vary the terms or conditions of this guarantee.
7.
This guarantee is offered as an additional benefit to your statutory rights, and does not affect these rights in any
way.
way.
If you have any difficulty operating this product, or would like information on other Sharp products, please telephone the
Sharp Customer Information Centre on the number given below.
Sharp Customer Information Centre on the number given below.
Sharp Customer Information Centre - Telephone 0345 125387
TINSE0264AWZZ
A9904.HK