Panasonic DP-C262 / DP-C322 (serv.man2) Service Manual ▷ View online
105
APR 2005
Ver. 1.1
DP-C262/322
(24) Unhook 4 Link Arm Springs (3408).
(25) Set 4 Link Arms to the locked position as
illustrated.
(26) Remove 4 Black Screws (Y29) from the right
side.
106
DP-C262/322
APR 2005
Ver. 1.1
(27) Remove 4 Black Screws (Y29) from the left
side.
(28) Remove the Handle Plate Bracket Assembly.
Caution:
When Removing and Installing the Handle Plate
Bracket Assembly, hold both side of the Bracket as
illustrated and don’t touch the IT Belt.
Bracket Assembly, hold both side of the Bracket as
illustrated and don’t touch the IT Belt.
(29) Remove 1 Black Screw (Y29).
(30) Using a pair of pliers as illustrated, remove the
(30) Using a pair of pliers as illustrated, remove the
Right Position Plate (3417).
(31) Remove 1 Black Screw (Y29).
(32) Using a pair of pliers as illustrated, remove the
(32) Using a pair of pliers as illustrated, remove the
Left Position Plate (3416).
107
APR 2005
Ver. 1.1
DP-C262/322
(33) Place the IT Unit on its side with the side that has
the belt position mark facing upward.
(34) Bend the IT Unit at the bending point up to
maximum bending position.
Caution:
Confirm that the IT Unit is at the maximum bending
position for removing the IT Belt.
position for removing the IT Belt.
(35) Remove the IT Belt (3419).
Caution:
When Removing and installing the IT Belt, hold the
side band of the belt as illustrated. Don’t touch the
center of the belt, or the printing quality will be
affected.
side band of the belt as illustrated. Don’t touch the
center of the belt, or the printing quality will be
affected.
Note:
While removing the IT Belt, exercise care not to
snag the belt projections onto the frame of the IT
Unit.
snag the belt projections onto the frame of the IT
Unit.
(36) Straighten the IT Unit.
108
DP-C262/322
APR 2005
Ver. 1.1
(37) Remove 4 Snap Rings (3545) securing the FTR
by turning over the Protect Sheet as illustrated.
Note:
When removing snap rings, exercise care not to
remove the Snap Ring holding the Backup Roller.
remove the Snap Ring holding the Backup Roller.
(38) Remove 4 FTR (3546) by turning over the
Protective Sheet as illustrated.
<Cleaning the Tension Roller, Tension Shaft and
Backup Roller>
Backup Roller>
(39) Clean the Tension Roller, Tension Shaft and
Backup Roller with a soft cloth, saturated with
isopropyl alcohol, then clean them with a soft dry
cloth.
isopropyl alcohol, then clean them with a soft dry
cloth.
(40) Turn the IT Unit upside down.
Note:
When turning it upside down, hold properly by both
sides as illustrated.
sides as illustrated.
Click on the first or last page to see other DP-C262 / DP-C322 (serv.man2) service manuals if exist.