DOWNLOAD Panasonic UB-5365 / UB-5865 (serv.man2) Service Manual ↓ Size: 6.26 MB | Pages: 127 in PDF or view online for FREE

13

14

The Panaboard is used by hanging it on the wall or installing it on the stand (sold separately as an option).
When using the Panaboard by hanging it on the wall, refer to the description in this manual or the Installation Manual for UB-5365/
5865.
When using the Panaboard by installing it on the stand (sold separately), refer to the Installation Manual for UB-5365/5865 to
assemble the stand, then refer to the description below except for sections 4.4 and 4.5 for installation.

Since the Panaboard is precision equipment, the operation is affected by the installation environment.
Avoid usage in the following environment to secure stable operation.

(1) Outdoor use or the environment below:

- Exposure to direct rain or water (includes space under the eaves)
- Location with much moisture and oil such as factories and kitchens, and special environment such as in combustible atmo-

sphere

- On the sea or seaside, and where corrosive gas is generated
- Locations exceeding usage temperature range (ambient temperature of 10 to 35 

°C

, humidity of 30 to 80%)

(2) Under direct sunlight, or near cooler/heater

Before installing the Panaboard, be sure to secure space shown in section 2.6.

- Must be within 3 m from the installation position of the Panaboard
- Must not be behind the Panaboard

15

The following parts are included in the Panaboard main body product box. Check that all parts are included before installation. Take
out the Board Attachment Upper (A1) and Board Attachment Lower (A2) from the component box. 

16

The way of hanging the Panaboard depends largely on the structure of the wall. Consult the building manager, the managing
 engineer, or the designer in advance, whether the structure of the wall is suitable for hanging the heavy system to the wall.
 For safety, consult the selection of attachment bolt (sold on the open market) and the construction method sufficiently before
attachment.

(1) Tools necessary for assembly
      Phillips screwdriver
      Drill
      Measuring tape
      Level
      Dust pump
      Hammer
      Torque driver (*1 The torque needs to be specified)

(2) Parts required for wall hanging construction
      Anchors: 4 pcs
      M6 bolts: 4 pcs
      Flat washers: 4 pcs
      Spring washers: 4 pcs

• Before mounting the electronic board, read through the following points, and take care to avoid accidents.

— To ensure that the work is accomplished safely and properly, make it a basic rule to strictly
     observe all other applicable aspects of safety control.
— If there is a chance that the unit has ended up being deformed or damaged by unexpected impact 
    while it was being transported and installed, do not install it without taking appropriate measures.
    Otherwise, it may fall off the wall.

• Avoid mounting the unit on a wall, which is not a principal structure component [a concrete wall which is at least 120 mm

(4.73 in.) thick], with a plasterboard, plywood or other such construction since these walls are weak.
If mounting on such a wall is unavoidable, reinforce the wall adequately (by ensuring that its ultimate strength will be
at least as great as the specified pullout strength of the anchors).