DOWNLOAD Panasonic DMP-BD75EB / DMP-BD75EE / DMP-BD75EF / DMP-BD75EG Service Manual ↓ Size: 4.85 MB | Pages: 62 in PDF or view online for FREE

13

1

Turn the unit on and off

2

TV operation buttons
You can operate the TV through the unit’s remote control.
[

TV] : Turn the television on and off

[ ] : Switch the input select
[

K L VOL] : Adjust the volume

3

Select title numbers, etc./Enter numbers.

4

Cancel

5

Select audio

6

Basic playback control buttons

7

Show status messages

8

Show Top menu/DIRECT NAVIGATOR

9

Show OPTION menu

10 Coloured buttons (red, green, yellow, blue)

These buttons are used when;

●

Operating a BD-Video disc that includes Java

TM

applications (BD-J).

11 Transmit the remote control signal
12 Open or close the disc tray

Do not place objects in front of the unit. The disc tray may
collide with objects when it is opened, and this may cause
malfunction.

13 Show playback menu
14 Switch on/off Secondary Video (Picture-in-picture)
15 Start up the DLNA function
16 Exit the menu screen
17 Show Pop-up menu
18 Show HOME menu
19 Selection/OK, Frame-by-frame
20 Return to previous screen

1

Standby/on switch ( /I)
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.

2

Disc tray

3

USB port

4

Display

5

Remote control signal sensor
Distance: Within approx. 7 m
Angle: Approx. 20

G up and down, 30G left and right

6

Stop

7

Start play

8

Open or close the disc tray

1

2

3

6

4
5

7

18

17

20

19

14

13

15

16

12

11

8

9

10

1

2

3

4

6 7

8

5

14

1. Turn the unit off, then press and hold [OK], [Yellow] and [Blue] buttons on the remote control simultaneously for 5 seconds.

- “00 RET” is displayed on the unit’s LED display.

2. Repeatedly press the right cursor button on the remote Control or Power button on the unit until “06 FTO” is displayed on the

unit's LED display.

3. Press [OK] button on the remote control or [OPEN/CLOSE] button on the unit.

Press [POWER] button on the unit for over 4 seconds to turn off the power forcibly, and step 1 to 3 above.

1. Turn off the power and pull out AC cord.
2. Remove the Top Case.
3. Put the unit so that bottom can be seen.
4. Insert paper clips, etc. into the hole on the bottom of Drive Unit and slide the paper clips, etc. in the direction of the arrow to

eject tray slightly.

5. Pull the unit upward, and push out Tray by paper clips, etc. or minus screw driver (small).

15

This unit uses the Micro Fuse.
Check the Micro Fuse conducting using the Tester at the check points below.

16

The remote control which included this unit is possible pressing multiple buttons simultaneously (Multiple Pressing function), and
can operate for the customer's initial settings and the Service Mode, etc.
The Multiple Pressing function is not available for conventional models' remote control. Use the remote control included this unit.

For pressing the multiple buttons of the remote control, this unit can be entering each of the following special modes.
After entering each mode, and then go to the menu you want to run.