Panasonic DMP-BD45EB / DMP-BD45EE / DMP-BD45EF / DMP-BD45EG / DMP-BD65EB / DMP-BD65EF / DMP-BD65EG Service Manual ▷ View online
25
9 Service Fixture & Tools
26
10 Disassembly and Assembly Instructions
10.1. Unit
10.1.1.
Disassembly Flow Chart
The following chart is the procedure for disassembling the casing and inside parts for internal inspection when carrying out the ser-
vicing.
To assemble the unit, reverse the steps shown in the chart below.
vicing.
To assemble the unit, reverse the steps shown in the chart below.
10.1.2.
P.C.B. Positions
27
10.1.3.
Top Case
1. Remove the 2 screws (A) and 3 screws (B).
2. Slide Top Case rearward and open the both ends at rear
2. Slide Top Case rearward and open the both ends at rear
side of the Top Case a little and lift the Top Case in the
direction of the arrows.
direction of the arrows.
10.1.4.
Front Panel
1. Unlock 6 tabs (A) - (F) turn.
Pull with the Front Panel in the direction of your side.
10.1.5.
Power SW P.C.B. and FL P.C.B.
10.1.5.1. Power SW P.C.B. and FL P.C.B.
1. Remove the screw (A).
2. Remove the Power SW P.C.B.
3. Remove the 2 screws (B).
4. Remove the FL P.C.B..
2. Remove the Power SW P.C.B.
3. Remove the 2 screws (B).
4. Remove the FL P.C.B..
10.1.5.2. How to assemble the Tray door
ass’y
1. Attach the Tray door spring to Tray door ass’y.
2. Attach Tray door ass’y in order from [1] to [2].
[1]: Insert the shaft to the hole.
[2]: Insert the shaft to the hole.
[2]: Insert the shaft to the hole.
28
3. Confirm the Tray door spring is attached as following.
10.1.6.
Rear Panel
1. Remove the 4 screws (A) and screw (B).
2. Unlock 2 locking tabs (A) to remove the Rear Panel.
2. Unlock 2 locking tabs (A) to remove the Rear Panel.
10.1.7.
BDP/Digital P.C.B. Module
CASE 1:
When replacing the pair of BD Drive and Digital P.C.B.
(Do not remove OPU FFC and 18 pin FFC between BD
Drive and Digital P.C.B.)
(Do not remove OPU FFC and 18 pin FFC between BD
Drive and Digital P.C.B.)
1. Remove the connector (A).
2. Remove the 3 screws (A) to remove Digital P.C.B..
3. Remove the 4 screws (B) to remove BD Drive.
2. Remove the 3 screws (A) to remove Digital P.C.B..
3. Remove the 4 screws (B) to remove BD Drive.
4. Put Digital P.C.B. on BD Drive and remove BDP/Digital
P.C.B. Module.
Click on the first or last page to see other DMP-BD45EB / DMP-BD45EE / DMP-BD45EF / DMP-BD45EG / DMP-BD65EB / DMP-BD65EF / DMP-BD65EG service manuals if exist.