Panasonic CQ-xxx Service Manual / Other ▷ View online
IDC Module 4 : Removal and Reinstallation of the Stocker block.
Replace the stocker springs onto the housing plates.
Remember: The
outer
two springs are stronger than the
inner
two springs..
WEAKER
Part Two,14
Reinstalling the Stocker block
IDC Module 4 : Removal and Reinstallation of the Stocker block
Part Two,15
Reinstalling the Stocker block
Place the Rear Disc
Guide Assembly onto
the Main Chassis.
Make note of the
alignment points. The
shaft
must be inserted
into the
eyelet
and the
tab
into the
chassis
.
IDC Module 4 : Removal and Reinstallation of the Stocker block
Part Two,16
Reinstalling the Stocker block
Place the stocker assembly
cover plate on top of the
stocker block. Be sure that
Push
Lever #2
is inserted on
the inside of the stocker
spring
and that the Disc
Guide Assembly is mated
with the
alignment points
underneath the stocker cover
plate on the top side of the
unit.
Top View
IDC Module 4 : Removal and Reinstallation of the Stocker block
Part Two,17
Reinstalling the Stocker block
Slightly lift the
cover plate and
insert the stocker
thrust springs on
top of the Cam
Gears
#1
and
#2
.
Partially tighten
each screw to
retain the springs
as the assembly
continues.
Click on the first or last page to see other CQ-xxx service manuals if exist.