LG WDT1652BDS Service Manual ▷ View online
3
2
①
① Unscrew the 2 screws from upper of the cabinet
Cover and the screw of dispenser.
②
② Unscrer the 2 screws from pump case
③
③ Put a flat ( - ) screwdriver or putty knife into the both
sides of the filter cover, and pull it out.
④
④ Unscrew the screw from the lower side of the cabinet
cover.
CABINET COVER
3
3
⑤
⑤ Open the door.
⑥
⑥ Disassemble the clamp assembly.
⑦
⑦ Tilt the cabinet cover.
⑧
⑧ Disconnect the door switch connector.
※
※ NOTE: When assembling the CABINET
COVER, connect the connector.
⑨
⑨ After remove the 3 hooks, Lift and separate the cabinet
cover.
⑩
⑩ Disassemble the clamp assembly.
⑪
⑪ Disassemble the Gasket.
3
4
①
① Open the door.
②
② Unscrew the 7 screws from the HINGE COVER.
③
③ Put a flat ( - ) screwdriver into the openng of the hinge,
and pull out the hinge cover.
④
④ Unscrew a screw from the lower side of door.
⑤
⑤ Disassemble the door upward.
DOOR
①
① Open the door and disassemble the CLAMP
ASSEMBLY.
②
② Unscrew the 2 screws.
DOOR LOCK SWITCH ASSEMBLY
※
※ Be careful! The door is heavy.
※
※ NOTE
• Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
3
5
PUMP
Heater & Thermistor
①
①
Disassemble the cabinet cover.
②
②
Separate the pump hose, the bellows
and the circulation hose assembly from the
pump assembly.
pump assembly.
③
③
Disassemble the pump assembly in arrow
direction.
①
①
Disassemble the cabinet cover.
②
②
Separate 2 connectors from the heater.
③
③
Loosen the nut and pull out the heater.
※
※ CAUTION
• When assembling the heater, insert the
heater into the heater clip on the bottom of
the tub.
the tub.
• Tighten the fastening nut so the heater is
secure.
Click on the first or last page to see other WDT1652BDS service manuals if exist.