DOWNLOAD LG WDT1652BDS Service Manual ↓ Size: 9.79 MB | Pages: 43 in PDF or view online for FREE

YES

YES

YES

YES

YES

NO

NO

NO

NO

NO

Connector

Connector

Hose Connector

(Water circulation

& Steam Nozzle)

Hose

Is the impeller of the drain pump clogged?

Are the Hose Connector and/or Hose clogged?

Is the connector disconnected, disassembled?

Is the coil of the right side of drain pump open
or short circuited? (Coil R is 18-30 

Ω)

When checking voltage between the 
connectors during spin, is the voltage 120 V AC,
as the figure?

Remove foreign material.

Remove foreign material.

Reconnect or repair 
the connector.

Replace PUMP MOTOR
ASSEMBLY.

Replace the MAIN PWB
ASSEMBLY.

(1)

(2)

Check the SENSOR SWITCH
ASSEMBLY or HOSE (Pressure). 
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.

Normal

Correct the connection.

Replace the STATOR
ASSEMBLY

Check during spin if the frequency of the water
level is 248 or more. 

Press the  START/PAUSE button 2 times in QC
Test mode, is the drum spinning at low speed?

Is it disconnected, or disassembled?
[Red: 3pin (1), NA: 4pin (2)]

Check the motor connector, Is the resistance of
the terminal the same as the figure?
MOTOR TERMINAL

Resistance of terminal: 

- / - / - : About 5 

Ω-15 Ω

Replace the MAIN PWB ASSEMBLY

Does the spring of Latch Hook actuate?

Is there clicking sound once or twice when the
START/ PAUSE button is pressed to start the cycle?

Is DOOR SWITCH ASSEMBLY broken?

Replace Door Assembly.

Check the DOOR SWITCH
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
(Red 3 pin, Yellow 4 pin and
white 3 pin connector (1)).

Replace the DOOR
SWITCH ASSEMBLY.

①

① Disconnect the POWER connector and SENSOR

SWITCH ASSEMBLY.

②

② Remove the Protect Cover.

③

③ Disconnect the connectors.

④

④ Unscrew 1 screw on the back.

⑤

⑤ Disassemble the Main PWB.

PROTECT COVER

MAIN PWB ASSEMBLY

9. DISASSEMBLY INSTRUCTIONS

Be sure to unplug the machine out of the outlet before disassembling and repairing the parts. 

①

① Disassemble the top plate assembly.

②

② Pull out the drawer.

③

③ Push out the DISPENSER ASSEMBLY after

unscrew 2 screws.

④

④ Unscrew the nut at the lower part of the dispenser.

⑤

⑤ Disassemble the 4 connectors from the valves.

⑥

⑥ Unscrew 2 screws from the back of the cabinet.

①

① Disassemble two (or three) connectors from 

the NOISE FILTER.

②

② Unscrew a screw from the TOP BRACKET.

※

※ Wire Color

①

① Blue Housing (YL-BK)

②

② Red Housing(VT-BK)

③

③ White Housing(WH-BK)

④

④ Blue Housing(GY-BK)

Red Housing(BL-BK)

DRAWER

5

DISPENSER ASSEMBLY

NOISE FILTER