LG WD-15CFD Service Manual ▷ View online
5
2-2.FUZZY LOGIC WASHING TIME OPTIMIZATION
To get the best washing performance, optimal time is determined by the water temperature,
the selected washing temperature, and the size of the load.
2-3.WATER LEVEL CONTROL
This model incorporates a pressure sensor which can sense the water level in the tub.
The water supply is stopped when the water level reaches the preset level, the washing
program then proceeds.
Spinning does not proceed until the water in the tub drains to a certain level.
2-4.DOOR CONTROL
The door can be opened by pulling the door handle whenever washer is not in operation.
When the cycle is completed, the DOOR LOCKED light will turn off.
If a power failure has occurred while in operation, the door will lock for 5 minutes.
Clicking sounds can be heard when the door is locked/unlocked.
FUZZY
LOGIC
load
size
selected
washing
temperature
water
temperature
washing time
rinsing time
spin speed, time
the best
washing
performance
washing
performance
SENSING
PROCESSING
DETERMINATION
EFFECT
6
3. PARTS IDENTIFICATION
ACCESSORIES
• If the supply cord is
damaged, it must be
replaced by the
manufacturer or an
authorized service
technician in order to
avoid a hazard.
replaced by the
manufacturer or an
authorized service
technician in order to
avoid a hazard.
7
Before servicing, ask the customer what the trouble is.
Check the setup (power supply is 120V AC, remove the transit bolts....).
Check with the troubleshooting guide.
Plan your service method by referring to the disassembly instructions.
Service the unit.
After servicing, operate the appliance to be sure it functions correctly.
Check the setup (power supply is 120V AC, remove the transit bolts....).
Check with the troubleshooting guide.
Plan your service method by referring to the disassembly instructions.
Service the unit.
After servicing, operate the appliance to be sure it functions correctly.
STANDARD INSTALLATION
The appliance should be installed as follows
REMOVE THE TRANSIT
INSTALL THE APPLIANCE
ADJUST THE
BOLTS
ON A FLAT AND FIRM SURFACE
LEVELING
Remove the transit bolts
Turn the leveling feet to adjust
(4 each) with the supplied wrench.
the appliance horizontally.
Keep the transit bolts and
wrench for future use.
Insert the 4 caps
(provided) into the holes.
The appliance goes up by
rotating the feet clockwise.
The appliance comes down by
rotating the feet counterclockwise.
4. INSTALLATION
8
HOW TO CONNECT THE INLET HOSE
Verify that the rubber washer is inside the
hose connector.
Connect the inlet hose firmly to prevent leaks.
CONNECT THE DRAIN HOSE
CONNECT POWER PLUG
The end of the drain hose should be placed less than 96” from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices, as
doing so may cause a fire.
doing so may cause a fire.
Make sure that the hose is not twisted.
Avoid submerging the end of the hose.
Click on the first or last page to see other WD-15CFD service manuals if exist.