LG TR1103AEP5 Service Manual ▷ View online
37
2) Disassembly of Back Panel, Power
Cord, Inlet Valve & BP Sensor
Hinge Pin
Hinge Pin
Remove two back panel fixing screws in the
back side.
back side.
1
Disassemble the back panel.
2
Disconnect two connectors and disassemble
the power cord.
the power cord.
3
Remove the inlet valve.
5
Remove the BP sensor.
7
Disconnect the leads & the pressure tube from
the BP sensor.
the BP sensor.
6
Remove a valve fixing screw & disconnect the
leads form the inlet valve.
leads form the inlet valve.
4
38
3) Disassembly of Back cover, Drain
Pump.
Remove back cover fixing screws then
disassemble the back cover.
disassemble the back cover.
1
Disconnect the leads and the drain hose-p from
the drain pump.
the drain pump.
2
Remove the pump fixing screws and the
connector hose disassemble the drain pump.
connector hose disassemble the drain pump.
3
4) Replacement of Damper asm
Separate top cover from washing machine.
1
For assembly, keep the following.(Location & color)
4
As in the fig, lift snubber bar and take it out of
out case with out tub.
out case with out tub.
2
Damper assembly shall not be disassembled.
Replace damper as assembly.
Replace damper as assembly.
3
Location
P/No.
PIVOT(Color)
,
,
,
K100
WHITE
A
B
D
C
39
Water Guide
Fixing Bolt
Hall Sensor
Stator Housing
6) Replacement of Rotor & Stator
Disassemble rotor nut with boxer(M18) or spaner.
(
(
In assembled, the force is over than 200kgf.cm)
Disassemble rotor, pull out the rotor as shown the
figure.
figure.
Disconnect fixing screw and disassemble the water
guide.
guide.
Before disassemble stator,disconnect the hall sensor
and stator housing.
and stator housing.
40
7) Replacement of Bearing housing asm
SNAP RING.
Hall Sensor
Stator Housing
Water Guide
Loosen the 6 fixing screws on the stator.
(Lower
(Lower
upper position screws)
Check the direction of SNAP RING.
(The handle of snap ring is toward to rotor and stator.)
(The handle of snap ring is toward to rotor and stator.)
Preventing fallen the stator, tighten with one hand and
then loosen the last screw.
then loosen the last screw.
For assembly take care lead wire's state, it produce a
noise and cut attach the rotor.
noise and cut attach the rotor.
Loosen 14 Fixing screws on the Bearing Housing ASM
and pull up it.
and pull up it.
Click on the first or last page to see other TR1103AEP5 service manuals if exist.