LG LS-H0560CL Service Manual ▷ View online
—20—
1) Checking the Drainage
1. Remove the Grille from the cabinet.
• Set the up-and-down air direction louver to open
position (horizontally) by finger pressure.
• Remove the securing screws.
• To remove the Grille, pull lower the left and right
• To remove the Grille, pull lower the left and right
side of the grille toward you (slightly tilted) and lift
it straight upward (Two tabs on the top inside
edge of the grille are clear of their slots).
it straight upward (Two tabs on the top inside
edge of the grille are clear of their slots).
2. Check the drainage.
• Pour a glass of water on the evaporator.
• Ensure if water flows drain hose of indoor unit
• Ensure if water flows drain hose of indoor unit
without any leakage.
Screw
(Both the left and the right side)
Pull on the right and the left side.
4. Checking the Drainage and Connecting the cable to Indoor unit
—27—
Disassembly of the parts (Indoor unit)
Warning :
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
To remove the Grille from the Chassis.
• Remove the securing screws.
• To remove the Grille, pull the lower left and right
• Remove the securing screws.
• To remove the Grille, pull the lower left and right
side of the grille toward you (Slightly tilted) and lift it
straight upward.
straight upward.
1. To remove the sensor, housing connector,
earth conductor.
Screw
—28—
2. To remove the Control Box.
• Remove 3 securing screws.
• Pull the control box out from the chassis carefully.
• Pull the control box out from the chassis carefully.
3. To remove the Discharge Grille.
• Remove the securing screw.
• Pull the discharge grille out from the chassis
• Pull the discharge grille out from the chassis
carefully.
4. To remove the Evaporator.
• Remove the securing screw.
—29—
• Unhook the tab on the left inside edge of the
chassis by pressing it outwards and at the same
time, slightly pull the evaporator until the tab is
clear of the end-plate.
time, slightly pull the evaporator until the tab is
clear of the end-plate.
• Remove the evaporator from the chassis
carefully.
• Unhook the tab on the right inside of the chassis
at the same time, slightly pull the evaporator
toward you until the tab is clear of the slot.
toward you until the tab is clear of the slot.
5. To remove the Cross-Flow Fan.
• Loosen the screw securing the cross-flow fan to
the fan motor (do not remove).
• Pull the left end of the cross-flow fan with the
self-aligning bearing out the groove.
• Remove the cross-flow fan by sliding it out from
the shaft of fan motor.
6. To remove the Fan Motor.
• Pick it up from the groove. (Do not remove a
black rubber as a spacer).