Harman Kardon SB 30 (serv.man2) EMC - CB Certificate ▷ View online
Report No:W-N-1109009-CY-01-1
Telecom Technology Center
6.5 SCREENING EFFECTIVENESS (S4)
scrip
o EN 55020:2007, item 5.5, for Measurement of screening effectiveness.
is
enna input terminal, there is no requirement for measuring
se signal do not occur.
6.5.2 Test Procedure
The test requirement was in accordance with EN 55020: 2007, item 5.5
6.5.1 De
tion
According t
For this EUT without ant
screening effectiveness, and adver
29
Report No:W-N-1109009-CY-01-1
Telecom Technology Center
6.6 RADIATED FIELDS (S5)
6.6.1 Test Limit
Equipment not fitting inside the open strip line shall be measured according
IEC61000-4-3 in the frequency range 80MHz to 150MHz
Test Item
Test Specification
900MHz
(duty cycle 1/8 217Hz repetition frequency)
3V/m.
(duty cycle 1/8 217Hz repetition frequency)
3V/m.
Radiated Signal(S5)
Parameter
Test
specification
Test set-up
Applicability
Performance
criteria
*)
RF e.m. field
Keyed carrier
Keyed carrier
900 MHz, 3
V/m,
duty cycle
1/8,
217 Hz
repetition
frequency
V/m,
duty cycle
1/8,
217 Hz
repetition
frequency
IEC 61000-4-3
With
measurement
conditions of
5.8.4. and
Table 23.
Filter B.2
replaced by
B.4.
With
measurement
conditions of
5.8.4. and
Table 23.
Filter B.2
replaced by
B.4.
Mains powered:
– FM radio antenna
– TV antenna
– Ass. video tun. ant.
– Ass. video
– Ass. audio
– Ass. other (e.g.
audio amplifier)
– Camcorders, in
playback-mode,
– Satellite TV
– Satellite radio
– FM radio antenna
– TV antenna
– Ass. video tun. ant.
– Ass. video
– Ass. audio
– Ass. other (e.g.
audio amplifier)
– Camcorders, in
playback-mode,
– Satellite TV
– Satellite radio
A
*)
As an alternative method, a non-homogeneous field strength ≥3 V/m of similar
characteristics as the test specification (e.g. generated by a dummy GSM portable
telephone) may be applied in a shielded room.
The dummy shall be placed on a non-metallic stand with a height of 80 cm, at a distance of
1 m to the EUT (see Figure 11). The front side of the EUT shall be placed in parallel to the
antenna line of sight. The position shall be described in the measurement report.
In case of dispute, measurements shall be carried out in accordance with IEC 61000-4-3,
with measurement conditions given in 5.8.4 and Table 23, and filter B.2 replaced by B.4.
characteristics as the test specification (e.g. generated by a dummy GSM portable
telephone) may be applied in a shielded room.
The dummy shall be placed on a non-metallic stand with a height of 80 cm, at a distance of
1 m to the EUT (see Figure 11). The front side of the EUT shall be placed in parallel to the
antenna line of sight. The position shall be described in the measurement report.
In case of dispute, measurements shall be carried out in accordance with IEC 61000-4-3,
with measurement conditions given in 5.8.4 and Table 23, and filter B.2 replaced by B.4.
6.6.2 Test Procedure
The test requirement was in accordance with EN 55020: 2007, item 5.8
6.6.3 Deviation From Test Standard
No deviation
30
Report No:W-N-1109009-CY-01-1
Telecom Technology Center
6.6.4 Test Setup
yed carrier (S5)
Immunity Against ke
31
Report No:W-N-1109009-CY-01-1
Telecom Technology Center
6.6.5 Test Photographs
32
Click on the first or last page to see other SB 30 (serv.man2) service manuals if exist.