Harman Kardon HS 200 (serv.man6) EMC - CB Certificate ▷ View online
Report No. JSH006110476-001
Page 28 of 69
8. Immunity requirements for the antenna input connector
8.1 Requirements for input immunity to RF voltages (in differential mode) of the VHF band II part of
sound receivers and of satellite sound receivers
sound receivers and of satellite sound receivers
8.1.1 Test result
Pass Fail Not Applicable
8.1.2 Operating environment
Temperature: 22
°C
Relative Humidity: 43 %
8.1.3 Test set-up
Sound receivers with a VHF band II part shall meet the sound criterion of subclause 6.1.1 of
the standard. They were be tested at a tuned frequency fn and subjected to an unwanted signal of
frequency ff and level fn as specified in Table 3 and 4 of the standard. Receivers with mono/stereo
facility was be tested in stereo mode.
frequency ff and level fn as specified in Table 3 and 4 of the standard. Receivers with mono/stereo
facility was be tested in stereo mode.
8.1.4 Test protocol
FMmode
Recorded data for test of input immunity from unwanted signals outside the VHF band II range
Below
Recorded data for test of input immunity from unwanted signals outside the VHF band II range
Below
Report No. JSH006110476-001
Page 29 of 69
Above
Recorded data for test of input immunity from unwanted signals inside the VHF band II range
Report No. JSH006110476-001
Page 30 of 69
8.2 Requirements for input immunity to RF voltages ( in differential mode) of television receivers and
video tape equipment (including satellite television receivers) (S1, S1a)
video tape equipment (including satellite television receivers) (S1, S1a)
8.2.1 Test result
Pass Fail Not Applicable
8.2.2 Operating environment
Temperature: 23
°C
Relative Humidity: 34 %
8.2.3 Test set-up
Television receivers and video tape equipment with built-in television broadcast receiving
facility in the RF recording mode shall be tested at a tuned television channel N and subjected to an
unwanted signal in channel M, level nf, and of the following types:
Unwanted
unwanted signal in channel M, level nf, and of the following types:
Unwanted
signal
types:
A: an unwanted signal at the picture carrier frequency of the relevant channel M
B: two unmodulated signals each at the level as given in the table, one at the relevant picture
carrier frequency +0.5MHz and the other at the picture carrier frequency –0.5MHz.
carrier frequency +0.5MHz and the other at the picture carrier frequency –0.5MHz.
C: a modulated signal at the relevant sound carrier frequency, 1kHz FM at 30kHz deviation
C shall be applied to receivers for countries in which moni-sound television signals of the
systems B and G can be received.
systems B and G can be received.
For television receivers for countries in which also two-sound-channel-television-signals of
the systems B and G with two frequency modulated sound with two frequency modulated
sound carriers can be received.
the systems B and G with two frequency modulated sound with two frequency modulated
sound carriers can be received.
C1: a modulated signal at the relevant frequency of the first sound carrier, 1kHz FM
at 30 kHz deviation, and
C2: a modulated signal at the relevant frequency of the second sound carrier, 1kHz
FM at 30kHz deviation.
C1 and C2 are applied simultaneously.
D: a modulated signal at the relevant picture carrier frequency, 1kHz AM at 80% depth;
E: a modulated signal 1kHz AM at 80% depth.
8.2.4 Test protocol
Report No. JSH006110476-001
Page 31 of 69
8.3 Requirements for immunity to RF voltages ( in common mode) (S2b)
8.3.1 Test result
Pass Fail Not Applicable
8.3.2 Operating environment
Temperature: 23
°C
Relative Humidity: 34%
8.3.3 Test set-up
The requirements for receivers,(including car radios and AM receivers), multifunction
equipment and video tape equipment concerning the immunity to RF voltages in common model are
restricted to the antenna terminals and to the frequency range form 26MHz to 30MHz.
restricted to the antenna terminals and to the frequency range form 26MHz to 30MHz.
8.3.4 Test protocol
Limits of immunity to RF voltages of antenna terminals of receivers and multifunction equipment
Click on the first or last page to see other HS 200 (serv.man6) service manuals if exist.