Harman Kardon AVR 170 EMC - CB Certificate ▷ View online
Page 1 of 5
Report No.: 209462
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
ANNEX TO TEST REPORTS
REGULATORY REQUIREMENTS FOR SINGAPORE
Annex Form No. .............................. : SG_RR_A
Annex Form Originator ..................... : TÜV SÜD PSB Pte Ltd
Master Annex Form .......................... : 2008-03
Copyright © 2008 IEC System for Conformity Testing and Certification of Electrical Equipment
(IECEE), Geneva, Switzerland. All rights reserved.
(IECEE), Geneva, Switzerland. All rights reserved.
No
Items
Requirements
Result - Remark
Verdict
The following is the national differences in accordance with safety authority website
www.spring.gov.sg/safety, ref. Singapore Consumer Protection (Safety Requirements) – Information
Booklet – Chapter 7.
7 SAFETY AUTHORITY’S REQUIREMENTS
The Safety Authority monitors the safety of the controlled goods sold in Singapore by
investigating all complaints, incidents and accidents reported to the authority. Experiences gained
are translated into the Safety Authority’s Requirements. These requirements are to be fulfilled in
addition to the applicable safety standards.
No
www.spring.gov.sg/safety, ref. Singapore Consumer Protection (Safety Requirements) – Information
Booklet – Chapter 7.
7 SAFETY AUTHORITY’S REQUIREMENTS
The Safety Authority monitors the safety of the controlled goods sold in Singapore by
investigating all complaints, incidents and accidents reported to the authority. Experiences gained
are translated into the Safety Authority’s Requirements. These requirements are to be fulfilled in
addition to the applicable safety standards.
No
Items
Requirements
Result - Remark
Verdict
Applicable to all products
1
Test certificate
/ Test report
/ Test report
Test certificate / Test report more
than three (3) years old shall be
rejected.
than three (3) years old shall be
rejected.
Noted —
2
Controlled
Goods
incorporated
with additional
function
Goods
incorporated
with additional
function
The additional function must be
tested to its applicable safety
standard.
tested to its applicable safety
standard.
N/A
Applicable to all electrical products
3 All
appliances
All appliances must be tested to 230
VAC.
VAC.
Covered
P
4
Voltage
selector
(voltage mis-
match test)
selector
(voltage mis-
match test)
Appliance fitted with voltage
selector shall be tested as follows:
Connect appliance to 230 VAC
mains with voltage selector switch
to settings not suitable for operation
at 230 VAC.
selector shall be tested as follows:
Connect appliance to 230 VAC
mains with voltage selector switch
to settings not suitable for operation
at 230 VAC.
No voltage selector.
N/A
5
Tropical
condition test
condition test
All appliances (with tropical test
requirements in applicable
Standards) shall comply with the
tropical condition test as stated in
the relevant IEC Standards.
requirements in applicable
Standards) shall comply with the
tropical condition test as stated in
the relevant IEC Standards.
Comply
P
Page 2 of 5
Report No.: 209462
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
6
Class I
appliances
(3-pin mains
plug)
appliances
(3-pin mains
plug)
All Class I appliances must be fitted
with 3-pin mains plugs complied
with SS 145/SS 472 that are
registered with the Safety Authority.
with 3-pin mains plugs complied
with SS 145/SS 472 that are
registered with the Safety Authority.
Class II apparatus
N/A
7
Class II
appliances
(mains plug)
appliances
(mains plug)
a) All Class II appliances must be
fitted with 2-pin mains plug
(Appendix T) complied with EN
50075.
b) Class II appliances that are fitted
with 3-pin mains plugs must use
plugs that are complied with SS 145
and registered with the Safety
Authority.
fitted with 2-pin mains plug
(Appendix T) complied with EN
50075.
b) Class II appliances that are fitted
with 3-pin mains plugs must use
plugs that are complied with SS 145
and registered with the Safety
Authority.
See appended table, list of
critical components, and
comments in Summary
of Testing.
critical components, and
comments in Summary
of Testing.
P
8
Appliances
rated ≥ 3 kW
or connected
to fixed wiring
rated ≥ 3 kW
or connected
to fixed wiring
Electric appliance ≥ 3 kW must be
connected to fixed wiring. All
connection to fixed wiring must be
in accordance with Code of Practice
CP5.
connected to fixed wiring. All
connection to fixed wiring must be
in accordance with Code of Practice
CP5.
Not exceed 3kW
N/A
9
Detachable
power cord
set (consists
of mains plug,
mains cord
and appliance
connector
power cord
set (consists
of mains plug,
mains cord
and appliance
connector
Detachable power cord set must be
listed in the test report critical
component list.
listed in the test report critical
component list.
See appended table, list of
critical components, and
comments in Summary
of Testing.
critical components, and
comments in Summary
of Testing.
P
10
Circuit
diagrams
diagrams
Circuit diagrams must be indicated
with component’s values for
products tested to IEC 60065 and
IEC 60950.
with component’s values for
products tested to IEC 60065 and
IEC 60950.
Comply
P
11
Circuit
diagrams of
electronic
modules in
electrical
appliances
diagrams of
electronic
modules in
electrical
appliances
Circuit diagrams of the electronic
modules in the electrical appliances
must be provided.
modules in the electrical appliances
must be provided.
No such module in the
apparatus
apparatus
N/A
12
Controlled
goods likely to
be treated as
toy by children
goods likely to
be treated as
toy by children
Controlled goods, having an
enclosure, which is shaped and
decorated so that it is likely to be
treated as a toy by children, shall
not be accepted for certification and
registration.
enclosure, which is shaped and
decorated so that it is likely to be
treated as a toy by children, shall
not be accepted for certification and
registration.
Apparatus is not likely to be
treated as a toy by children.
treated as a toy by children.
N/A
Page 3 of 5
Report No.: 209462
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
No
Items
Requirements
Result - Remark
Verdict
Applicable to electric airport
13 Reboil
Switch
No part of the reboil switch is
allowed to protrude into the water
pot, even if it is located above the
maximum water level mark.
allowed to protrude into the water
pot, even if it is located above the
maximum water level mark.
No electric airport
N/A
Applicable to AC adaptor
14
3-pin AC
adaptor
(Appendix V)
adaptor
(Appendix V)
Test report showing that the 3-pin
complied with sub-clauses 12.1 &
12.3 of SS 246 must be submitted.
complied with sub-clauses 12.1 &
12.3 of SS 246 must be submitted.
No AC adaptor
N/A
15
2-pin AC
adaptor
(Appendix V)
adaptor
(Appendix V)
The 2-pin (Appendix T) shall comply
with EN 50075.
with EN 50075.
N/A
16
Detachable
power supply
cord set not
supplied by
Registered
Supplier
power supply
cord set not
supplied by
Registered
Supplier
Registered Supplier who is not
supplying the detachable power
supply cord set together with the
AC Adaptor must provide written
instruction to its customer on the
type of approved detachable power
cord set to use.
supplying the detachable power
supply cord set together with the
AC Adaptor must provide written
instruction to its customer on the
type of approved detachable power
cord set to use.
N/A
Applicable to computer products
17
CD/DVD ROM
(used in
personal
computer)
(used in
personal
computer)
Test certificate showing that
CD/DVD ROM has complied with
IEC 825 must be provided.
CD/DVD ROM has complied with
IEC 825 must be provided.
No CD/DVD ROM.
N/A
18
Modem Card
(used in
personal
computer)
(used in
personal
computer)
Modem card incorporated in the
personal computer must be tested
at set level (sub-clauses 5.1 & 6 of
IEC 60950) or at component level.
personal computer must be tested
at set level (sub-clauses 5.1 & 6 of
IEC 60950) or at component level.
No modem.
N/A
Applicable to ceiling fan and cycle fan
19
Ceiling fan
and cycle fan
and cycle fan
a) These appliances must be tested
to sub-clauses 5.7 and 5.8 of SS
360: 1992.
b) Installation instruction must
mention the 3 expansion bolts for
fastening the main suspension,
safety cord, expansion bolt with
hook for fastening safety cord and
mounting plate. (Appendix Q)
c) Drawing (Appendix P) to show
that the wires within the motor shaft
are not stressed must be provided.
to sub-clauses 5.7 and 5.8 of SS
360: 1992.
b) Installation instruction must
mention the 3 expansion bolts for
fastening the main suspension,
safety cord, expansion bolt with
hook for fastening safety cord and
mounting plate. (Appendix Q)
c) Drawing (Appendix P) to show
that the wires within the motor shaft
are not stressed must be provided.
No ceiling fan and cycle fan.
N/A
Page 4 of 5
Report No.: 209462
ATTACHMENT 4
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Applicable to portable/wall socket-outlet and portable cable reel
20
Portable/wall
socket-outlet
and portable
cable reel
socket-outlet
and portable
cable reel
a) If residual current device (RCD)
is incorporated, its tripping current
must be less than 30mA and
operating time must be less than
0.1 second and testing to sub-
clauses 9.9.2.1, 9.9.2.2, 9.9.2.3 and
9.16 of SS 97: Part 1: 2000 are
required.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
is incorporated, its tripping current
must be less than 30mA and
operating time must be less than
0.1 second and testing to sub-
clauses 9.9.2.1, 9.9.2.2, 9.9.2.3 and
9.16 of SS 97: Part 1: 2000 are
required.
b) The shutters screening the
current-carrying socket contacts
shall not be opened by the insertion
of any corresponding SINGLE pin
of the plug into any current-carrying
socket aperture.
No portable/wall socket-
outlet and portable
cable reel.
outlet and portable
cable reel.
N/A
21
Wall switched
socket-outlet
(2 x single
socket-outlet)
socket-outlet
(2 x single
socket-outlet)
Single socket-outlet with 2-gang
faceplate/frame must be fulfilled
with the test requirements as 2-gang
socket-outlet.
faceplate/frame must be fulfilled
with the test requirements as 2-gang
socket-outlet.
N/A
22
Remote
controlled
portable/wall
portable
socket-outlet
controlled
portable/wall
portable
socket-outlet
Remote controlled portable/wall
socket-outlet shall not be
allowed for registration.
socket-outlet shall not be
allowed for registration.
N/A
Applicable to roaster
22 Roaster
A metal ring (Appendix U) must be
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
provided to prevent the roaster from
falling off in case the glass bowl
shattered.
No roaster.
N/A
Applicable to Residual Current Circuit Breaker (RCCB)
33 RCCB
Registration of RCCB is limited to
30 mA sensitivity and the operating
time must be less than 0.1 second.
Electronic RCCB will not be
accepted for registration.
30 mA sensitivity and the operating
time must be less than 0.1 second.
Electronic RCCB will not be
accepted for registration.
No Residual Current Circuit
Breaker.
Breaker.
N/A
Applicable to electric instantaneous and storage water heater
34
Instantaneous
electric water
heater and
mains
pressure
electric storage
water heater
electric water
heater and
mains
pressure
electric storage
water heater
Heating elements used must not be
of the "bare-element" type.
of the "bare-element" type.
No electric instantaneous
and storage water heater.
and storage water heater.
N/A
35
Water heater
incorporated
with residual
current
device(RCD)
incorporated
with residual
current
device(RCD)
Testing to sub-clauses 9.9.2.1,
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
9.9.2.2, 9.9.2.3 and 9.16 of SS 97:
Part 1: 2000 are required.
N/A
Click on the first or last page to see other AVR 170 service manuals if exist.