DOWNLOAD Sony KV-27FA210 Service Manual ↓ Size: 2.95 MB | Pages: 55 in PDF or view online for FREE

5

This jack connects to the Audio input jacks on your audio 
equipment. You can listen to your TV’s audiio through your 
stereo system.

6

The Dynamic Bass Response System (subwoofer) accentuates 
the low frequencies for better overall sound.

01US01COV-BR2.book  Page 10  Monday, August 4, 2003  5:05 PM

Depending on the cable system available in your home, choose one of the connections below:

✍

If you are connecting to an indoor or outdoor antenna, you may need to adjust the orientation of the 
antenna for the best reception. 

Use this to connect the TV to a cable system or an antenna with a 75-ohm cable 
(usually built in to newer homes).

Use this to connect the TV to a dipole antenna, also known as a “rabbit ears antenna” 
(usually found in older homes).

This allows you to connect your TV to both a cable system and a dipole antenna, in order to
view both cable and local channels.

01US01COV-BR2.book  Page 11  Monday, August 4, 2003  5:05 PM

Introduce the support bolt of the Dynamic Bass Response System into the guide located 
on top of the TV.

Connect the Dynamic Bass Response System cables (supplied) to the indicated inputs of 
the TV rear panel. Connect the gray cable to the SUBWOOFER 

 (gray input). Connect 

the black cable to the SUBWOOFER 

 (black input). See illustration below.

Once installation is complete, plug the TV's AC powercord into the wall socket.

•

Disconnect the TV before connecting the Dynamic Bass Response System.

•

Do not connect anything other than the KV-27FA210 Sony TV to the Dynamic Bass 
Response System (SUBWOOFER +/-) inputs.

✍

Use only the supplied cables, otherwise your TV will not work.

✍

Do not plug in the AC powercord until the subwoofer is completely installed.

1

3

4

Licensed by BBE Sound, Inc.
under USP4638258, 4482866.
BBE and the BBE symbol are
trademarks of BBE Sound, Inc.

5

01US01COV-BR2.book  Page 12  Monday, August 4, 2003  5:05 PM

Connect the coaxial cable from your TV antenna or cable service to the IN jack on your 
VCR.

Connect a coaxial cable (not supplied) from the OUT jack on your VCR to the VHF/UHF 
jack on the TV.

❏

If your VCR is equipped with video outputs, you can get better picture quality by 
connecting audio/video cables (not supplied) from AUDIO/VIDEO OUT on your VCR to 
AUDIO/VIDEO IN on your TV. 

❏

For better picture quality, use S VIDEO instead of the yellow video cable. S VIDEO does 
not provide sound, so you still must connect the audio cables.

This connection allows you to do the following:

❏

Program your Sony remote control to operate your VCR (see page 5).

❏

To activate your remote, press 

 to operate your VCR.  To do this, first program your 

remote control, then use the Channel Fix feature to set your TV to channel 3 or 4 (see page 29).

❏

Press 

 repeatedly to switch between VCR input (VIDEO input) and VHF/UHF 

(local channels).

1

3

4

5

01US01COV-BR2.book  Page 13  Monday, August 4, 2003  5:05 PM