Sony KDL-65S990A Service Manual ▷ View online
KDL-65S990A 25
ACCESSORIES AND PACKAGING
2-580-608-01
SCREW, +PSW M5X16
(SCREWS TO ATTACH TABLE-TOP STAND TO LCD TV)
For product protection and safety reasons, Sony strongly recommends
that you use the screws provided with the TV.
CAUTION: These screws cannot be used to secure the TV
to the Wall Mount Brackets.
4-472-757-11
MANUAL, INSTRUCTION
MISCELLANEOUS
PART NO.
DESCRIPTION
4-462-810-12
FLYER, SAFETY
4-262-708-04
CLAMPER, CABLE
7-600-031-97
TAPE (3M 1350FB-1) 15MMX66M BLK
4-487-578-01
PANEL, CUSHION
Order this part when required (Refer to
page 12
).
4-487-577-01
CUSHION SUPPORT
Order this part when required (Refer to
page 12
).
OPTIONAL ACCESSORIES
PART NO.
DESCRIPTION
4-443-737-02
SUPPORT BELT KIT
X-2586-996-1
PASSIVE 3D GLASSES
REMOTE COMMANDER
PART NO.
DESCRIPTION
1-491-987-11
REMOTE COMMANDER (RM-YD087)
1-492-077-13
ONE TOUCH REMOTE CONTROL (RMF-YD001)
SECTION 5 - ACCESSORIES/PART NUMBER INFORMATION
PART NO.
DESCRIPTION
Sony Corporation
Sony LCSC
Technical Services
Service Publications Department
9-883-543-02
English
2013HJ74WEB-1
© 2013.8
is a trademark of Sony Electronics.
Reproduction in whole or part without written permission is prohibited. All rights reserved.
KDL-65S990A A-1
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential information and shall be handled under the non-disclosure obligations provided
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
1.
In the service manual the Circuit Board(s) containing encryption key components shall be identified with a red outline and a .
2. Only repair boards or components listed in the service manual shall be utilized for replacement and/or repair.
3. Disassembly, decryption or reverse-engineering component(s) is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be placed back into the set it orignally came from and the replaced
defective component MUST BE DESTROYED. Boards cannot be swapped.
5.
If a Circuit Board identified with a red outline and a in the service manual is deemed to be defective:
a.
a.
and if a core charge is imposed and is covered under the product warranty, the defective un-repaired or modified board MUST BE RETURNED to
Sony.
Sony.
b.
and if the core charge is NOT covered under the product warranty, the defective un-repaired or modified board MUST BE DESTROYED.
6.
If a unit is destroyed (such as field scrap), the Circuit Board identified with a red outline and a in the service manual MUST BE DESTROYED.
Sony Corporation
Sony LCSC
Technical Services
Service Publications Department
9-883-543-02
English
2013HJ74WEB-1
© 2013.8
is a trademark of Sony Electronics.
Reproduction in whole or part without written permission is prohibited. All rights reserved.
KDL-65S990A A-1
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential information and shall be handled under the non-disclosure obligations provided
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
1.
In the service manual the Circuit Board(s) containing encryption key components shall be identified with a red outline and a .
2. Only repair boards or components listed in the service manual shall be utilized for replacement and/or repair.
3. Disassembly, decryption or reverse-engineering component(s) is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be placed back into the set it orignally came from and the replaced
defective component MUST BE DESTROYED. Boards cannot be swapped.
5.
If a Circuit Board identified with a red outline and a in the service manual is deemed to be defective:
a.
a.
and if a core charge is imposed and is covered under the product warranty, the defective un-repaired or modified board MUST BE RETURNED to
Sony.
Sony.
b.
and if the core charge is NOT covered under the product warranty, the defective un-repaired or modified board MUST BE DESTROYED.
6.
If a unit is destroyed (such as field scrap), the Circuit Board identified with a red outline and a in the service manual MUST BE DESTROYED.
Sony Corporation
Sony LCSC
Technical Services
Service Publications Department
9-883-543-02
English
2013HJ74WEB-1
© 2013.8
is a trademark of Sony Electronics.
Reproduction in whole or part without written permission is prohibited. All rights reserved.
KDL-65S990A A-1
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential information and shall be handled under the non-disclosure obligations provided
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
in the applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit Board containing encryption key components is repaired and/or replaced
pursuant to the following:
1.
In the service manual the Circuit Board(s) containing encryption key components shall be identified with a red outline and a .
2. Only repair boards or components listed in the service manual shall be utilized for replacement and/or repair.
3. Disassembly, decryption or reverse-engineering component(s) is strictly prohibited.
4. Any board in which the Servicer replaces an encryption key component must be placed back into the set it orignally came from and the replaced
defective component MUST BE DESTROYED. Boards cannot be swapped.
5.
If a Circuit Board identified with a red outline and a in the service manual is deemed to be defective:
a.
a.
and if a core charge is imposed and is covered under the product warranty, the defective un-repaired or modified board MUST BE RETURNED to
Sony.
Sony.
b.
and if the core charge is NOT covered under the product warranty, the defective un-repaired or modified board MUST BE DESTROYED.
6.
If a unit is destroyed (such as field scrap), the Circuit Board identified with a red outline and a in the service manual MUST BE DESTROYED.