Sony KDL-26S3000 / KDL-32S3000 / KDL-40S3000 / KDL-46S3000 Service Manual ▷ View online
49
KDL-26S3000/32S3000/40S3000/46S3000
KDL-26S3000/32S3000/40S3000/46S3000
KDL-32S3000 ONLY
1. Wire route ESD GND wire as shown
(NOTE: Actual Part will have RED insulation)
2. Use 3x12mm screw to fix ring terminal in
U1 Bracket
3mm TORQUE: 6.0kg-cm (+-1.0kg-cm)
OPERATION PROCESS
TORQUE SPECIFICATION
1
2
NO SIDE CLAMP
[DO NOT INSTALL]
[DO NOT INSTALL]
U1 BOARD (CONTINUED)
50
KDL-26S3000/32S3000/40S3000/46S3000
KDL-26S3000/32S3000/40S3000/46S3000
KDL-32S3000 ONLY
1. Dress/Route H1-Bd harness as shown
on photo.
2. NOTE: Put attention on SLACK of cable.
Between Connector on H1 and tape there
is slack in wire.
Between tape/clamp there is slack.
Between tape/DTT Shield there is slack.
OPERATION PROCESS
1
2
NOTE which connector
cables are attached to
on H1-Bd.
cables are attached to
on H1-Bd.
Plastic Side Clamp.
Installed by Vendor.
Installed by Vendor.
2
H1 BOARD
51
KDL-26S3000/32S3000/40S3000/46S3000
KDL-26S3000/32S3000/40S3000/46S3000
KDL-32S3000 ONLY
1. Route 40P LVDS Cable between
BU-Bd and TCON as shown.
2. Apply 3x8mm Screw (2-places) to ground
LVDS cable.
Put Attention on Routing of Cable.
G1 to BU cables are on TOP of LVDS.
H3-Bd cables are UNDER LVDS.
3mm TORQUE: 6.0kg-cm (+-1.0kg-cm)
OPERATION PROCESS
TORQUE SPECIFICATION
NOTE: LVDS Cable is UNDER G1/U-Bd cables
NOTE: LVDS Cable is ON TOP of H3-Bd Cables
1
2
2
LVDS CABLE
52
KDL-26S3000/32S3000/40S3000/46S3000
KDL-26S3000/32S3000/40S3000/46S3000
KDL-32S3000 ONLY
Route LVDS Harness from BU-Board
(CN4500) as shown.
CAUTION: Keep LVDS Wires AWAY from
Memory IC and JIG Connectors!
OPERATION PROCESS
CAUTION:
Keep LVDS Cables AWAY from JIG Connectors
and Memory IC.
LVDS CABLE (CONTINUED)
Click on the first or last page to see other KDL-26S3000 / KDL-32S3000 / KDL-40S3000 / KDL-46S3000 service manuals if exist.