Sony VPL-VW200 Service Manual ▷ View online
13
VPL-VW200
0x8003 Installation location
Alphanumeric 24 characters
If the number of characters is less than 24, the remaining digits are filled with 00h.
Alphanumeric 24 characters
If the number of characters is less than 24, the remaining digits are filled with 00h.
3-4-2-4. Network Information Acquisition (90**h)
Used to acquire the network setup information.
Lower bytes
Contents
SET
GET
00h
MAC Address
O
01h
IP Address
O
02h
Subnet Mask
O
03h
Default Gateway
O
04h
DHCP
O
0x9000 Mac Address
6 bytes
6 bytes
0x9001 IP Address
4 bytes
4 bytes
0x9002 Subnet Mask
4 bytes
4 bytes
0x9003 Default Mask
4 bytes
4 bytes
0x9004 DHCP
1 byte
DHCP invalid: 0
DHCP valid: 1
1 byte
DHCP invalid: 0
DHCP valid: 1
14
VPL-VW200
3-4-3. Error Code
The error code list is shown below with a detailed description of each.
Category
Error
Error Code
Item Error (01**h)
Invalid Item
01h
Invalid Item Request
02h
Invalid Length
03h
Invalid Data
04h
Short Data
11h
Not Applicable Item
80h
Community Error (02**h)
Different Community
01h
Request Error (10**h)
Invalid Version
01h
Invalid Category
02h
Invalid Request
03h
Short Header
11h
Short Community
12h
Short Command
13h
Network Error (20**h)
Timeout
01h
Comm Error (F0**h)
Timeout
01h
Check Sum Error
10h
Framing Error
20h
Parity Error
30h
Over Run Error
40h
Other Comm Error
50h
Unknown Response
F0h
NVRAM Error (F1**h)
Read Error
10h
Write Error
20h
15
VPL-VW200
3-4-3-1. Item Error
This error occurs when the Item No. of a request is illegal or its data is illegal. The conditions for occur-
rence of the respective errors are shown below.
rence of the respective errors are shown below.
Invalid Item
An unsupported Item No. is specified.
An unsupported Item No. is specified.
Example 1: The unsupported category 0xA** is specified.
Example 2: The unsupported Item No. 0x8010 is specified.
Example 2: The unsupported Item No. 0x8010 is specified.
Invalid Item Request
The Item No. is supported but an unsupported Request is issued.
The Item No. is supported but an unsupported Request is issued.
Example: An attempt is made to set data in the Model Name (0x8001).
Invalid Length
Data length of the specified Item No. is too long.
Data length of the specified Item No. is too long.
Example: An attempt is made to set 25 byte data in the installation location (0x8003).
Invalid Data
Data of the specified Item No. is outside the setting range.
Data of the specified Item No. is outside the setting range.
Example: An attempt is made to set 101 in the Item when the setting range of the Item is 1 to 100.
Short Data
The length of data is shorter than the value specified by the data length.
The length of data is shorter than the value specified by the data length.
Example: The actual data length is 9 bytes but data length is 10.
Not Applicable Item
An item that is not valid at present is specified.
An item that is not valid at present is specified.
Example: The item to switch the display is specified when the main power is off.
3-4-3-2. Community Error
This error occurs when community is different.
Example: “ABCD” is specified when “SONY” is set.
16
VPL-VW200
3-4-3-3. Request Error
This error occurs when header or command is illegal. The conditions of occurrence of the respective
errors are shown below.
errors are shown below.
Invalid Version
The version of the header is other than 2.
n
When another version is supported, an error occurs in all versions other than the supported version.
The version of the header is other than 2.
n
When another version is supported, an error occurs in all versions other than the supported version.
Invalid Category
The category does not match.
The category does not match.
Example: 0x0B is specified in the device of category = 0x0A.
Invalid Request
An unsupported request is specified.
An unsupported request is specified.
Example: Request = 0x02 is specified.
Short Header
The received data is 1 byte.
The received data is 1 byte.
Short Community
The received data is in the range of 2 to 5 bytes.
The received data is in the range of 2 to 5 bytes.
Short Command
The received data is in the range of 6 to 9 bytes.
The received data is in the range of 6 to 9 bytes.
3-4-3-4. Network Error
This is an error that occurs in TCP/IP. The conditions of occurrence of the respective errors are shown
below.
below.
Timeout
Communication was interrupted.
Communication was interrupted.
Click on the first or last page to see other VPL-VW200 service manuals if exist.