DOWNLOAD Sony DCR-TRV940 / DCR-TRV940E / DCR-TRV950 / DCR-TRV950E (serv.man3) Service Manual ↓ Size: 7.2 MB | Pages: 127 in PDF or view online for FREE

You can use these buttons to check the recorded picture or shoot so that the transition
between the last recorded scene and the next scene you record is smooth.

You can go to the end of the recorded section after you record.

(1) In the standby, press FN to display PAGE1.
(2) Press END SCH.

The last five seconds of the recorded section are played back and your
camcorder returns to the standby. You can monitor the sound from the speaker
or headphones.

Press EXIT.

Press END SCH again.

End search
When you use a cassette without cassette memory, the end search function does not
work once you eject the cassette after you have recorded on the tape. If you use a
cassette with cassette memory, the end search works even once you eject the cassette.

If a tape has a blank portion between recorded portions
The end search may not work correctly.

You can search for the next recording start point.

Hold down the EDITSEARCH in the standby. The recorded portion is played back.

– 7 : To go backward
+

: To go forward

Release EDITSEARCH to stop playback. If you press START/STOP, recording begins
from the point you released EDITSEARCH. You cannot monitor the sound.

FN

EDITSEARCH

You can check the last recorded section.

Press the  – 7  side of EDITSEARCH momentarily in the standby.
The section you have stopped most recently will be played back for a few seconds, and
then your camcorder will return to the standby. You can monitor the sound from the
speaker or headphones.

You can monitor the playback picture on the screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can control playback using the
Remote Commander supplied with your camcorder.

(1) Prepare the power supply and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button.
(3) Open the LCD panel while pressing OPEN.
(4) Press m to rewind the tape.
(5) Press N to start playback.
(6) To adjust the volume, press either of the two buttons on VOLUME.

– : To turn down
+ : To turn up
When you close the LCD panel, sound is muted.

Press x.

VOLUME

REW

PLAY

POWER

OFF(CHG)

CAMERA

MEMORY/

NETWORK

VCR

When monitoring on the LCD screen
You can turn the LCD panel over and move it back to the camcorder body with the
LCD screen facing out.

If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.

When you open or close the LCD panel
Make sure that the LCD panel is set vertically.