Sony SDM-X75F / SDM-X75K / SDM-X95F / SDM-X95K Service Manual ▷ View online
OPERATING INSTRUCTIONS
9
SDM-X75F, K / SDM-X95F, K(E)
10
SDM-X75F, K / SDM-X95F, K(E)
10
SDM-X75F, K / SDM-X95F, K(E)
SERVICE MODE
To enter service OSD menu,
1) Turn off the power switch button.
2) Press volume down, and then power key.
3) Shows the service OSD menu. That menu is located in down side of main menu.
4) The service OSD menu contains additional menus as described below.
2) Press volume down, and then power key.
3) Shows the service OSD menu. That menu is located in down side of main menu.
4) The service OSD menu contains additional menus as described below.
Service Mode Explanations
「COLOR TEMP」
Adjust R/G/B color values of contrast and brightness in 9300k, 6500k color mode(Factory Setting Area).
「CLEAR EEPROM」
Initialize the EDID DATA at DDC2B EEPROM is saved system memory.
COLOR TEMP data becomes the default “128”. User table data is reset.
COLOR TEMP data becomes the default “128”. User table data is reset.
「CLR. ETI」
Initialize the used time of MNT
「AGING」
Select aging mode (on/off) Default is OFF.
「WHITE BALANCE」
Adjust the offset voltage and gain value in Analog RGB.
「DEFAULT TIMING」
To select 1152×870 or 1152×864. Default is 1152×870.
「MODULE」
To select applied module
When you replace A board or Panel, it is required to set the Panel inch size and the Panel maker name on
selecting “MODULE”.
When you replace A board or Panel, it is required to set the Panel inch size and the Panel maker name on
selecting “MODULE”.
11
SDM-X75F, K / SDM-X95F, K(E)
12
SDM-X75F, K / SDM-X95F, K(E)
Click on the first or last page to see other SDM-X75F / SDM-X75K / SDM-X95F / SDM-X95K service manuals if exist.