Sony SAL50F18 Service Manual ▷ View online
HELP
SAL50F18 (DT 1.8/50 SAM) (DT 50mm F1.8 SAM)
HELP02
How to remove the connection board
1.
Remove two stopper screws securing connection board.
2.
Push down the inner side of connection board.
3.
Remove the Main PC board assy with shifting the outside of connection board to inward.
How to attach the connection board
1.
Push the outside of connection board to outward.
2.
Instal the Main PC board assy with pushing up the inside of connection board.
3.
Tighten two stopper screws securing connection board.
2
1
3
1
2
3
Connection
Board
Board
Connection
Board
Board
Stopper screws of connection board
Connection
Board
Board
Stopper screws of connection board
Outside
Inside
Connection
Board
Board
Outside
Inside
Main PC Board Assy
Main PC Board Assy
HELP
SAL50F18 (DT 1.8/50 SAM) (DT 50mm F1.8 SAM)
HELP03
How to remove the switch panel block (Scar prevention)
1.
Remove three screws fixing the rear mirror assy tube.
2.
Set the switch panel block to “AF”.
3.
Hold down the midway mirror tube and pull up the rear mirror assy tube slightly to the direction of the mount until the
indicated hole of rear mirror assy tube is seen.
4.
Insert tweezers or a narrow tip stick in the hole of rear mirror assy tube and peel the switch panel block by pushing it from the inside
with the tweezers or the narrow tip stick.
Note on the switch panel block installation
1.
Set the select switch of DC motor (geared) to AF.
2.
Set the knob of switch panel block to AF.
3.
Peel the released paper off the switch panel block and install the switch panel block.
Midway Mirror Tube
Direction of the mount
Rear Mirror Assy Tube
Switch Panel Block
Narrow tip stick
Hole
Select switch of
DC Motor (Geared)
DC Motor (Geared)
Knob
Switch Panel Block
AF Side
MF Side
HELP
SAL50F18 (DT 1.8/50 SAM) (DT 50mm F1.8 SAM)
HELP04
1.
Install the rear mirror assy tube, aligning the installation hole of switch panel block with the select switch DC motor (geared).
2.
Fix it with three screws.
HELP05
1.
Affix the flexible of DC motor (geared) to the midway mirror tube.
2.
Connect the PC board joint flexible to the connector.
Installation hole of
Switch Panel Block
Switch Panel Block
Select switch of
DC Motor (Geared)
DC Motor (Geared)
Rear Mirror Assy Tube
DC Motor (Geared)
Midway mirror tube
PC Board Joint Flexible
Connector
HELP
SAL50F18 (DT 1.8/50 SAM) (DT 50mm F1.8 SAM)
HELP06
1.
Fold the PC board joint flexible as shown in the illustration.
2.
Affix the PC board joint flexible along the reference.
HELP07
1.
Install the interception by inserting three pins of interception in the three
oblong holes
of filter screw frame.
Note:
Install it so that each cut portion of interception is located in 90˚ and 270˚ with respect to the Distance index.
PC Board Joint Flexible
Reference for affixing
Crest folds
Valley folds
Interception
Pin
Distance index
Cut portion
Oblong hole
Oblong hole
Main Unit Assy
Ver. 1.2 2009.10
The changed portions from
Ver. 1.1 are shown in blue.
Ver. 1.1 are shown in blue.
Click on the first or last page to see other SAL50F18 service manuals if exist.